02 Jul 2012
Are you sure the installation media is good? Where did you obtain it?
It may be a hardware issue. Try a hardware stripdown.
Diskpart Clean Command:
Before you proceed with the following, answer these two questions: Are you still under warranty? Does your warranty allow you to open up the machine to check hardware?
If you are unsure of the answers to these questions, contact your system manufacturer. WARNING: The steps that follow can void your warranty!!!
Strip down your system to run only the bare essentials: one RAM module, the CPU, motherboard, one hard disk, one graphics card (or use onboard graphics if you have it), keyboard, mouse, and one monitor. See how the system behaves by running Windows for twice as long as it typically takes for you to get a crash. If it is stable, add one piece of hardware back at a time until you get crashes again. Take notes of what hardware you add and how the system responds to the hardware changes.
As you add and remove hardware, follow these steps for ESD safety:
Once these steps have been followed, it is safe to remove and replace components within your computer.
- Shut down and turn off your computer.
- Unplug all power supplies to the computer (AC Power then battery for laptops, AC power for desktops)
- Hold down the power button for 30 seconds to close the circuit and ensure all power drains from components.
- Make sure you are grounded by using proper grounding techniques, i.e. work on an anti-static workbench, anti-static desk, or an anti-static pad. Hold something metallic while touching it to the anti-static surface, or use an anti-static wristband to attach to the anti-static material while working. If you do not have an anti-static workbench, desk, or pad, you can use your computer tower/case by finding a metal hold in it, such as a drive bay.
You may also need to run the Clean command (Not the Clean All command) using Diskpart prior to installing Windows: Disk - Clean and Clean All with Diskpart Command
|My System Specs