View Single Post
08 Jul 2012  
writhziden

Windows 7 Home Premium 64 Bit
 
 

Device Concerns:
Code:
SM Bus Controller	PCI\VEN_8086&DEV_1C22&SUBSYS_1C221849&REV_05\3&11583659&0&FB	The drivers for this device are not installed.
Standard VGA Graphics Adapter	PCI\VEN_8086&DEV_0112&SUBSYS_01121849&REV_09\3&11583659&0&10	This device cannot start.
PCI Simple Communications Controller	PCI\VEN_8086&DEV_1C3A&SUBSYS_1C3A1849&REV_04\3&11583659&0&B0	The drivers for this device are not installed.
Take care of the above. The above contain some important drivers for the system to function properly. Install all drivers from Z68 Motherboard Series Manufacturing - ASRock Inc., but do not install the utilities.

Software Concerns:
MSI Afterburner/RivaTuner is known to cause instability with systems. Please remove the software. Software overclocking does not provide reliable overclocking. Overclocking should be accomplished through the BIOS or through the graphics card manufacturer's software.

Analysis:
You do not have all drivers, BIOS updates, etc. installed. That can cause issues with the SSD.

SSD Troubleshooting:
  • Make sure the following are up to date:
    • SSD firmware
    • BIOS Version
    • Chipset Drivers
    • Hard disk controller drivers/SATA drivers
    • If you have a Marvell IDE ATA/ATAPI device, make sure the drivers are up to date from the Intel site or Marvell site and not from your motherboard/vendor support site.

  • Try doing a power cycle of the SSD. The following steps should be carried out and take ~1 hour to complete.
    1. Power off the system.
    2. Remove all power supplies (ac adapter then battery for laptop, ac adapter for desktop)
    3. Hold down the power button for 30 seconds to close the circuit and drain all components of power.
    4. Reconnect all power supplies (battery then ac adapter for laptop, ac adapter for desktop)
    5. Turn on the system and enter the BIOS (see your manual for the steps to enter the BIOS)
    6. Let the computer remain in the BIOS for 20 minutes.
    7. Follow steps 1-3 and physically remove the SSD from the system by disconnecting the cables for a desktop or disconnecting the drive from the junction for a laptop.
    8. Leave the drive disconnected for 30 seconds to let all power drain from it.
    9. Replace the drive connection(s) and then do steps 4-8 again.
    10. Repeat steps 1-4.
    11. Start your computer normally and run Windows.

    The above steps were a result of: Why did my SSD "disappear" from my system? - Crucial Community

    While that may not be your drive, a power cycle should be the same on all SSD drives. See how the system responds after the SSD power cycle.
My System SpecsSystem Spec