View Single Post
21 Aug 2012  

Microsoft Windows 7 Ultimate: x64 (SP1)

No problem.

You're getting this error because you haven't been running the software as an elevated program. When opening the SF Diagnostic Tool, right-click it and open it as Administrator.

BSOD Analyse

An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high.  This is usually
caused by drivers using improper addresses.
If a kernel debugger is available get the stack backtrace.
Arg1: 00000000000000dd, memory referenced
Arg2: 0000000000000002, IRQL
Arg3: 0000000000000001, bitfield :
	bit 0 : value 0 = read operation, 1 = write operation
	bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
Arg4: fffff80002ec8405, address which referenced memory
Combining your crash dumps and the general view of BSODs culprits, I'd suggest you to have a look at your memory, the sticks. Through decades people have been using the bootable tool called Memtest86+ and it's basically very unique in these manners.
Be sure to check your warranty rules and regulations before opening your case.
* Memtest86+ is USB-ready, and can be booted directly from it. Download the flashdrive wizard.
* To ensure that either your sticks OR your motherboard slots are broken, it's necessary to do the below procedure-
* Pull out all sticks except ONE, scan it.
* If no errors, pull the scanned stick into another slot.
* Proceed like this until you've scanned all sticks individually, and all the slots.
Best Regards,
My System SpecsSystem Spec