View Single Post
29 Aug 2012  
gregrocker
Microsoft MVP

 

OK, then enter BIOS setup to set to defaults. Then set SATA controller to AHCI to try install, IDE if that fails.

If that fails wipe the HD if not blank, then create a 100gb NTFS Primary partition marked Active from Step 2.2 here: SSD - HDD Optimize for Windows Reinstallation.

If that fails test the HD using WD Data Lifeguard extended CD scan: WD Support / Downloads / SATA & SAS / WD RE2 followed by Disk Check run from installer Command Line accessed by pressing Shift + F10 at first screen after boot.
My System SpecsSystem Spec