Setting RAID 0, Any way to back up my whole system?

Hi Rainess,

Unfortunately what you are proposing is very tricky to do for several reasons. If you do a search through the forum posts on RAIDO you will find several which have met with very little success - if you search back far enough, you will even find my original post about exactly what you are proposing. The fact is that installing an OS to a RAID0 just doesn't seem to be very succesful.

In theory you could image your existing setup using something like Macrium Reflect, then install your 2nd hard disk, configure the RAID controller, then restore your image back to the new RAID0. Unfortuantely, however, you are going to run into problems : one of them that I am aware of is that the REGISTRY will require a reference to the fact that your system is now a RAID, but your image you are restoring doesn't have that reference. There is probably some registry fix/hack for that, but I have never attempted it - I have seen others try it with very limited success.

A more robust solution is do a clean install of everything onto the new RAID, but even that doesn't seem very successful for most - I really don't know why. For this reason, many people here will advise you against using a RAID as an installation disk. Of course, a RAID0 is also a risky undertaking, since if a single disk should fail, then the entire RAID fails - you will lose everything on those disks.

Since you are looking for speed increase, and if you can afford it, I recommend considering a SSD as your OS disk, with the other disks as data/backup disks. This is the tried and tested solution that has worked for many here, and an SSD far outperforms any RAID0 I have worked with, and I have worked with some very quick RAID0 arrays.

Let us know what you decide.

Good luck,
Golden

Hi,

An SSD is definately the way to go for an OS. You can still create a RAID0 with your 2 HDD's later on, after installing your OS etc. to the SSD, but just be aware of the implications should one of these disks fail. A good backup policy is a must.

Regards,
Golden

When creating a RAID0 array you should use identical drives, preferrably of the same age. I had no problem at all installing win7 on my RAID0 array but i'm using the popular ICH10R southbridge which is fully supported by windows 7 without the need to import drivers from USB storage. In XP I did this by slipstreaming the drivers into my install.

Migrating an install from a single drive to an array as Golden said is feutile!

If an SSD is too expensive (they certainly are for me although the speed of the 3rd Gen SSD's is very impressive)

Could you stretch to buy another of the HDD's you just ordered? This will let you create a new array and start from scratch, plus you will still have your current drive and install with all your files intact!

NOTE: I would remove your current drive before installing and setting up the drives for the array to prevent confusion and possibly destroying your data. It can then be re-attached later and easily distinguished from the created array in the bios boot selection menu.