|28 Apr 2012||#1|
| || |
Restore Point settings weird error and can't save
Hi All, I just tried to create a Restore Point and was notified that Restore Points are turned off. I went into Control Panel and got to System Protection and tried to change the settings for C: and D: to "On." When I clicked "Apply," I got the following message.
Could not apply the settings for the following reasons
The filename, directory name, or volume label syntax is incorrect (0x8007007B)
I clicked Cancel and dropped back to the next page but now the C: and D: drives were showing "On" for protection despite that former message.
I then tried to change the amount of space for Restore Points and it gave the same message again, but this time did not accept the increase in size.
Any suggestions as to what to do to fix that error message issue? I checked the Drive Label and directory label and both are fine.
|My System Specs|
|Similar help and support threads for2: Restore Point settings weird error and can't save|
|Getting an error try to create a restore point (0x80042308)||Backup and Restore|
|How to permanently save a restore point||Backup and Restore|
|Restore Point ERROR (0x80004231F) Please try again.||Backup and Restore|
|Unable to restore - can save a restore point||Backup and Restore|
|Restore point error||Backup and Restore|
|System Restore- restore point creation error||Backup and Restore|
|Can you permanently save a good restore point||Backup and Restore|
|Our Sites ||Site Links ||About Us ||Find Us |
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.
© Designer Media Ltd
All times are GMT -5. The time now is 07:09 AM.