New
#521
Hi,
The winpe I made is 32bit.
Unfortunately, the .cmd file didn't work. I've posted the error message below..
** get access to PE_SYS hive **
INFO: Processing ACL of: <machine\PE_SYS>
ERROR: Reading the SD from <machine\PE_SYS> failed with: The system cannot find
the file specified.
SetACL finished with error(s):
SetACL error message: The call to GetNamedSecurityInfo () failed
Operating system error message: The system cannot find the file specified.
INFO: Processing ACL of: <machine\PE_SYS>
ERROR: Reading the SD from <machine\PE_SYS> failed with: The system cannot find
the file specified.
SetACL finished with error(s):
SetACL error message: The call to GetNamedSecurityInfo () failed
Operating system error message: The system cannot find the file specified.
Press any key to continue . . .
I used WAIK and the instructions on the MS website to make winpe. The default would open a command window. Then I added Paragon Backup & Recovery 2012 Free to the image, and got it to load on startup using the [LaunchApps] section in Winpeshl.ini. That was fine. But I haven't had any success with trying to get Easeus Partition Master 9.10 Home Edition (Free) to work, because of the issue with the registry.
My last step (if I got Easeus Partition Master 9.10 Home Edition (Free) to load correctly) would have been to create a small gui to start up with simple buttons on it to start either app or to open a command window. When I found your app I thought I could just use that rather than re-invent the wheel...