New
#11
<pedant mode>
m/c is not an acronym - it's an abbreviation.
m/c has existed as an abbreviation since long before the advent of the internet - or PC's for that matter.
</pedant mode>
php pages in IE10
-
-
New #12
OK mate, I see you are no help for me and many others! So I will assume it IS motor cycle which has been in use for years and the only one I know of. Bleah.
-
New #13
I don't have any default for .php from what i see (below).
I haven't seen the issue with PHP that huffman reported in the OP.
I just mentioned what i did because I see source code when I expect to see an HTML web page for the Belarc report...
My association for .html is Firefox, my default browser...
-
New #14
Maybe it's FF that's palming it off to Notepad++??
See what happens if you change your default browser to IE and then run Belarc - then switch back to FF and try again.
-
New #15
Good ideas...
Tried them and it always opens the Belarc results in Notepad++
IE as the default opens Notepad++ source file, and switching back to FF still does.
-
New #16
I'm really not concerned for myself about this, I just mentioned it because I see a similarity in the OP issue.
I don't want to hijack this thread, or confuse the issue.
For me, it's on a Test box and I can restore it...
-
New #17
I found and fixed my issue with Belarc Advisor opening the report with Notepad++.
It has nothing to do with IE 10.
I found an incorrect registry setting that Belarc somehow used to open the report.
I apologize for sidetracking this thread.
Thanks Noel for the help!
-
-
New #19
I changed the data from "Notepad++_file" to "htmlfile" in this key:
I probably should delete the Notepad++_backup key, but I want to check some other systems before doing that...
-
New #20
Interesting that the change didn't show in the Default Programs listing!
Could be the same issue with the .php for our OP??
Quote
Related Discussions