hi,
All the dumps blame on your Belkin N +Wireless USB Adapter driver as the cause, so I would recommend you to update that driver.
And your device driver for Zune has not been installed properly, better to check that driver as well.
These drivers need do be update:
Log
Code:
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
Use !analyze -v to get detailed debugging information.
BugCheck A, {fffff6fb41414140, 2, 0, fffff80002ab6a11}
Unable to load image \SystemRoot\system32\DRIVERS\netr28ux.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for netr28ux.sys
*** ERROR: Module load completed but symbols could not be loaded for netr28ux.sys
Probably caused by : netr28ux.sys ( netr28ux+b214 )
Followup: MachineOwner
---------
0: kd> !analyze -v
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
IRQL_NOT_LESS_OR_EQUAL (a)
An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high. This is usually
caused by drivers using improper addresses.
If a kernel debugger is available get the stack backtrace.
Arguments:
Arg1: fffff6fb41414140, memory referenced
Arg2: 0000000000000002, IRQL
Arg3: 0000000000000000, bitfield :
bit 0 : value 0 = read operation, 1 = write operation
bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
Arg4: fffff80002ab6a11, address which referenced memory
Debugging Details:
------------------
READ_ADDRESS: GetPointerFromAddress: unable to read from fffff80002cff0e0
fffff6fb41414140
CURRENT_IRQL: 2
FAULTING_IP:
nt!MmBuildMdlForNonPagedPool+81
fffff800`02ab6a11 488b4500 mov rax,qword ptr [rbp]
CUSTOMER_CRASH_COUNT: 1
DEFAULT_BUCKET_ID: VISTA_DRIVER_FAULT
BUGCHECK_STR: 0xA
PROCESS_NAME: System
TRAP_FRAME: fffff80000b9bf50 -- (.trap 0xfffff80000b9bf50)
NOTE: The trap frame does not contain all registers.
Some register values may be zeroed or incorrect.
rax=0000000000000932 rbx=0000000000000000 rcx=0000000000000000
rdx=0000000000001931 rsi=0000000000000000 rdi=0000000000000000
rip=fffff80002ab6a11 rsp=fffff80000b9c0e8 rbp=fffff6fb41414140
r8=000000000000000f r9=0000000282828280 r10=fffffa8007043730
r11=0505050505050000 r12=0000000000000000 r13=0000000000000000
r14=0000000000000000 r15=0000000000000000
iopl=0 nv up ei pl nz na po cy
nt!MmBuildMdlForNonPagedPool+0x81:
fffff800`02ab6a11 488b4500 mov rax,qword ptr [rbp] ss:0018:fffff6fb`41414140=????????????????
Resetting default scope
LAST_CONTROL_TRANSFER: from fffff80002ac6ca9 to fffff80002ac7740
STACK_TEXT:
fffff800`00b9be08 fffff800`02ac6ca9 : 00000000`0000000a fffff6fb`41414140 00000000`00000002 00000000`00000000 : nt!KeBugCheckEx
fffff800`00b9be10 fffff800`02ac5920 : fffffa80`00000000 fffffa80`07043760 fffffa80`08140010 fffff880`02832808 : nt!KiBugCheckDispatch+0x69
fffff800`00b9bf50 fffff800`02ab6a11 : fffffa80`070acc70 00000000`00000000 fffff880`028b5214 00000000`00000000 : nt!KiPageFault+0x260
fffff800`00b9c0e8 fffff880`028b5214 : 00000000`00000000 fffff800`02c44080 fffffa80`0736d800 fffffa80`0727f1a0 : nt!MmBuildMdlForNonPagedPool+0x81
fffff800`00b9c100 00000000`00000000 : fffff800`02c44080 fffffa80`0736d800 fffffa80`0727f1a0 fffffa80`00000002 : netr28ux+0xb214
STACK_COMMAND: kb
FOLLOWUP_IP:
netr28ux+b214
fffff880`028b5214 ?? ???
SYMBOL_STACK_INDEX: 4
SYMBOL_NAME: netr28ux+b214
FOLLOWUP_NAME: MachineOwner
MODULE_NAME: netr28ux
IMAGE_NAME: netr28ux.sys
DEBUG_FLR_IMAGE_TIMESTAMP: 4aaf19dd
FAILURE_BUCKET_ID: X64_0xA_netr28ux+b214
BUCKET_ID: X64_0xA_netr28ux+b214
Followup: MachineOwner
---------