StorageCraft Volume Snap-Shot Development Edition


  1. bellandbottle
    Posts : 24
    Windows 7 Ultimate 32-bit
       New #1

    StorageCraft Volume Snap-Shot Development Edition


    I have just had a crash, and WhoCrashed identified this software as possibly responsible. I did twitch because I had a really bad experience a few months ago with Corsair memory failures.

    I have just done a memtest 86 session with no problems showing.

    I have just read some reports which indicate that Norton products may be responsible - has anyone seen this before?

    I have Norton IS 2011 and Ghost 15.
      My Computer
    Quote Quote

  3. bellandbottle
    Posts : 24
    Windows 7 Ultimate 32-bit
    Thread Starter
       New #2

    Just an update to say that I just had another crash and I had Memtest 86 in my DVD drive and booted immediately from that - red screens!

    This is now the fourth set of Corsair memory I've had fail - the first set lasted 12 months, sets 2 & 3 were DOA, and this fourth set has last about 4 months.

    Lets see what Corsair have to say.
      My Computer
    Quote Quote

 

  Related Discussions
Screen Shot
in Software

Hi everyone I am Danny age 17, my Dad is americancritic, I was wondering if someone could point me to a screenshot software that I could use. Thank you very much for your time as I know you all must be very busy... I picked up Dad's 3 dots and I know what they stand for but the rules say...
Encrypted Volume Check: Volume Info on \\?\Volume{X}Can Not Read Found this in my Event Viewer on each start/restart. I don't have any Volumes that I have encrypted. Is this malware? I've run everything prior to noticing including Windows Offline Defender. Not sure if this is even the...
I seem to notice on chromium snap shots recently that when I clear the cache, then browse to a forum page with a skin, I get source "show through." The source is all jumbled like the browser has a lag before rendering. I tried the experimental GPU accleration settings on and off. Makes no...
how to screen shot?
in General Discussion

how do u screenshot? i clicked prt sc, does not work..?
How to Only Allow Explicitly Enabled MMC Snap-ins to Open in Windows This will show you how to selectively permit or prohibit the use of Microsoft Management Console (MMC) snap-ins for all users on the computer in Vista, Windows 7, and Windows 8. You will need to be logged in as an...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 20:06.
Find Us