Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


27 May 2011   #31

Windows 7 Home Premium 64bit

Here's the new report.

My System SpecsSystem Spec
29 May 2011   #32

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64

Go to your BIOS and increase the MCH Core voltage to 1.2v.

CPU - Stress Test with Prime95
Run Prime95 torture test.
First open Real Temp to monitor CPU temperatures, don't go over 76C.
Open Prime95 and stop the test if it is running, in Advanced tab select 'Round off checking', in the Options tab select 'Torture Test...', in the window that opens select 'Blend', after 'Number of torture test threads to run' enter 4, then click OK to start the test.

Run the test for two hours.

Intel Core™2 Quad Processor Q9550

*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high.  This is usually
caused by drivers using improper addresses.
If a kernel debugger is available get the stack backtrace.
Arg1: 0000000000007a83, memory referenced
Arg2: 0000000000000002, IRQL
Arg3: 0000000000000000, bitfield :
 bit 0 : value 0 = read operation, 1 = write operation
 bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
Arg4: fffff80002abb943, address which referenced memory
Debugging Details:
READ_ADDRESS: GetPointerFromAddress: unable to read from fffff80002cc10e0
fffff800`02abb943 f6819000000004  test    byte ptr [rcx+90h],4
PROCESS_NAME:  Azureus.exe
TRAP_FRAME:  fffff8800c17e4d0 -- (.trap 0xfffff8800c17e4d0)
NOTE: The trap frame does not contain all registers.
Some register values may be zeroed or incorrect.
rax=0000000000000001 rbx=0000000000000000 rcx=000000000ab48000
rdx=fffff98049578000 rsi=0000000000000000 rdi=0000000000000000
rip=fffff80002a804a0 rsp=fffff8800c17e668 rbp=fffffa8008913480
 r8=0000000000004000  r9=0000000000000200 r10=fffff780c0000488
r11=000000000ab48000 r12=0000000000000000 r13=0000000000000000
r14=0000000000000000 r15=0000000000000000
iopl=0         nv up ei ng nz na po cy
fffff800`02a804a0 488b040a        mov     rax,qword ptr [rdx+rcx] ds:fffff980`540c0000=????????????????
Resetting default scope
LAST_CONTROL_TRANSFER:  from fffff80002a88c69 to fffff80002a89700
fffff880`0c17de58 fffff800`02a88c69 : 00000000`0000000a 00000000`00007a83 00000000`00000002 00000000`00000000 : nt!KeBugCheckEx
fffff880`0c17de60 fffff800`02a878e0 : fffffa80`0b8aa110 00000000`00000001 fffffa80`08240b70 fffffa80`07ad5040 : nt!KiBugCheckDispatch+0x69
fffff880`0c17dfa0 fffff800`02abb943 : 00000000`00000000 00000000`00000000 00000000`00000000 00000000`00000000 : nt!KiPageFault+0x260
fffff880`0c17e130 fffff800`02aafe59 : 00000000`00000000 00000000`07a128c6 fffffa80`08240b70 fffff800`02c15e00 : nt!MiResolveTransitionFault+0x4a3
fffff880`0c17e1c0 fffff800`02aa55be : 00000000`00000000 fffff980`540c0000 fffff6fc`c02a0600 fffff800`02c15e00 : nt!MiResolveProtoPteFault+0x419
fffff880`0c17e260 fffff800`02aa3cf1 : 00000000`00000000 00000000`00000000 00000000`00000000 00000000`00000000 : nt!MiDispatchFault+0x1de
fffff880`0c17e370 fffff800`02a877ee : 00000000`00000000 00000000`00004000 00000000`00004000 00000000`00004000 : nt!MmAccessFault+0x8f1
fffff880`0c17e4d0 fffff800`02a804a0 : fffff800`02da5b81 00000000`00004000 00000000`00000000 fffffa80`0b800ae0 : nt!KiPageFault+0x16e
fffff880`0c17e668 fffff800`02da5b81 : 00000000`00004000 00000000`00000000 fffffa80`0b800ae0 00000000`00004000 : nt!memcpy+0xb0
fffff880`0c17e670 fffff800`02da5702 : 00000000`055c0000 00000000`0ab48000 00000000`00004000 00000000`00004000 : nt!CcCopyBytesToUserBuffer+0x41
fffff880`0c17e6b0 fffff880`012e6c48 : fffff880`00000000 00000000`00000005 fffffa80`00004000 fffffa80`00004001 : nt!CcCopyRead+0x1a2
fffff880`0c17e770 fffff880`010d80c8 : fffffa80`08913480 fffffa80`0b800a78 fffff880`0c17e9d0 fffffa80`08913401 : Ntfs!NtfsCopyReadA+0x1a8
fffff880`0c17e940 fffff880`010dbc2a : fffff880`0c17ea10 00000000`0ab48003 00000000`0ab48000 fffffa80`08913400 : fltmgr!FltpPerformFastIoCall+0x88
fffff880`0c17e9a0 fffff880`010f95f0 : fffffa80`08913480 00000000`00000000 fffff880`0c17eb00 00000000`00004000 : fltmgr!FltpPassThroughFastIo+0xda
fffff880`0c17e9e0 fffff800`02da5ff9 : fffffa80`08913480 fffffa80`00000001 fffffa80`06a13c90 fffffa80`08913480 : fltmgr!FltpFastIoRead+0x1d0
fffff880`0c17ea80 fffff800`02a88953 : 00000000`00001358 00000000`00000000 00000000`00000000 00000000`00000000 : nt!NtReadFile+0x417
fffff880`0c17eb70 00000000`753d2dd9 : 00000000`00000000 00000000`00000000 00000000`00000000 00000000`00000000 : nt!KiSystemServiceCopyEnd+0x13
00000000`0901f0f8 00000000`00000000 : 00000000`00000000 00000000`00000000 00000000`00000000 00000000`00000000 : 0x753d2dd9
fffff800`02abb943 f6819000000004  test    byte ptr [rcx+90h],4
SYMBOL_NAME:  nt!MiResolveTransitionFault+4a3
FOLLOWUP_NAME:  MachineOwner
IMAGE_NAME:  memory_corruption
FAILURE_BUCKET_ID:  X64_0xA_nt!MiResolveTransitionFault+4a3
BUCKET_ID:  X64_0xA_nt!MiResolveTransitionFault+4a3
Followup: MachineOwner

The process Azureus belongs to the software Azureus or Azureus Vuze or BitTyrant by Aelitis or Azureus, Inc or Azureus Inc or Vuze Inc.
Any malware can be named anything - so you should check where the files of the running processes are located on your disk. If a "non-Microsoft" .exe file is located in the C:\Windows or C:\Windows\System32 folder, then there is a high risk for a virus, spyware, trojan or worm infection!

Uninstall the bittorrent app for testing purposes. You can re-install after the cause is found.

Old drivers can cause crashes, check for new drivers or look for a new program, if this is for hardware and a 2009 or newer driver can't be found, then uninstall for testing purposes.
usbVM31b usbVM31b.sys Mon Sep 19 14:57:34 2005
My System SpecsSystem Spec
29 May 2011   #33

Windows 7 Home Premium 64bit

Looking at the program right now, I just took a screenshot of my systems temp as of this moment, checks out OK:
My System SpecsSystem Spec

29 May 2011   #34

Windows 7 Home Premium 64bit

i'll run the above test above tomorrow morning, i have to work tonight @ 10. i won't be able to monitor it while at work.
My System SpecsSystem Spec
29 May 2011   #35

Windows 7 Home Premium 64bit

and I use Vuze a lot, it doesn't give me any far as I know..
My System SpecsSystem Spec
29 May 2011   #36

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64

Were the above temps during the Prime95 torture test?
If those temps are at system idle, then you have a problem.

Uninstall Vuze, for testing purposes, it was indicated as the cause of your last crash.
You can re-install it later, or another bittorrent app, you have to eliminate the possible causes as we find them.

Let me know the answer to the above question, if you are having high CPU temps, this will need to be addressed first.
My System SpecsSystem Spec
30 May 2011   #37

Windows 7 Home Premium 64bit

Alright, as far the CPU temps, yes, those are the system idle temps. I haven't yet ran Prime95, but I am right now. What would I need to do about those pretty high temps? Would I need some kind of cooling put in? Do you still want me to change the voltage in the system bios to 1.2? It was hot out yesterday, around 77 degrees. Hot in my room too. Does that matter? I just removed Vuze now. Any torrent programs other than Vuze that you would recommend?
My System SpecsSystem Spec
30 May 2011   #38

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64

If you idle temps are in the 50-60C range then don't run prime95.

Your idle temp should be around 35C, 40C max.

Check if you CPU cooler is tight, it should not move or be able to twist it.
It will likely have four push pins, check that they haven't come loose.
Make sure the CPU cooler fan is rotating.

77F = 25C, that is not hot enough to affect the CPU idle temps.
My System SpecsSystem Spec


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar help and support threads
Thread Forum
Startup very slow,crash at welcome and crash randomlythen OS not found
A few weeks back PC crashed out of no where and BSOD appeared.. didnt take much notice until it says OS not found when restarting.. but after a few tries it went back to normal for a few days then these few days it started to startup very slowly and may sometimes crash after typing in the password...
BSOD Help and Support
Recent PC Build. CRASH...CRASH...CRASH
Okay guys, I'd love some help with some issues I am having. About two months ago I decided to start putting together parts to build my own rig(first time builder here) After scrounging around for a bit and getting the deals I liked I decided to put it all together and make my PC. Since then, Ive...
BSOD Help and Support
Crash on new PC Full Crash log zipped and included. Driver related?
So my new Cyberpower PC is crashing. I think it is a driver issue but this level of detail is beyond by "expertise" basic log below. Full diagnostic attached. Please let me know if additional information is needed. Problem signature: Problem Event Name: BlueScreen OS...
BSOD Help and Support
BSOD/crash appears to occur randomly, IRQL_not_less_or_equal
I've just put together a new machine so there's not much software running on it but I'm getting some sort of BSOD/crash at random times. Most of the times it occurs when I'm away from my machine so I won't see the actual error just windows rebooted with a message stating it was shutdown improperly....
BSOD Help and Support
HP Envy 17 1050ea crash, IRQL_NOT_LESS_OR_EQUAL
I have been getting a couple of crashes over this month with my HP laptop, and I am wondering what is wrong with it. From the blue screen, I always seem to see: IRQL_NOT_LESS_OR_EQUAL That is all I can remember before it restarts. I have also included the zip file necessary for diagnosis: ...
BSOD Help and Support
Laptop crash no response memory dump crash
My laptop, Packard Bell Easynote TM81, has been crashing and restarting by itself, and when it does, the ENTIRE system will not respond. So I try to format the entire thing, and after a few days, when I have gotten used to it, it comes up with a screen for 1 second, and all I could read was "system...
BSOD Help and Support

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 19:45.

Twitter Facebook Google+

Windows 7 Forums

Seven Forums Android App Seven Forums IOS App