New
#11
This is my dmp after a crash with verifier enabled
This is my dmp after a crash with verifier enabled
Driver verifier was not enabled for this DMP. It was blamed on memory corruption.
These were caused by a memory corruption Please run these two tests to verify your memory and find which driver is causing the problem.
1-Memtest.
*Download a copy of Memtest86 and burn the ISO to a CD using Iso Recorder or another ISO burning program. Memtest86+ - Advanced Memory Diagnostic Tool
*Boot from the CD, and leave it running for at least 5 or 6 passes.
Just remember, any time Memtest reports errors, it can be either bad RAM or a bad motherboard slot.
Test the sticks individually, and if you find a good one, test it in all slots.
RAM - Test with Memtest86+
2-Driver verifier
Driver Verifier - Enable and DisableI'd suggest that you first backup your data and then make sure you've got access to another computer so you can contact us if problems arise. Then make a System Restore point (so you can restore the system using the Vista/Win7 Startup Repair feature).
In Windows 7 you can make a Startup Repair disk by going to Start....All Programs...Maintenance...Create a System Repair Disc - with Windows Vista you'll have to use your installation disk or the "Repair your computer" option at the top of the Safe Mode menu .
Then, here's the procedure:
- Go to Start and type in "verifier" (without the quotes) and press Enter
- Select "Create custom settings (for code developers)" and click "Next"
- Select "Select individual settings from a full list" and click "Next"
- Select everything EXCEPT FOR "Low Resource Simulation" and click "Next"
- Select "Select driver names from a list" and click "Next"
Then select all drivers NOT provided by Microsoft and click "Next"
- Select "Finish" on the next page.
Reboot the system and wait for it to crash to the Blue Screen. Continue to use your system normally, and if you know what causes the crash, do that repeatedly. The objective here is to get the system to crash because Driver Verifier is stressing the drivers out. If it doesn't crash for you, then let it run for at least 36 hours of continuous operation (an estimate on my part).
If you can't get into Windows because it crashes too soon, try it in Safe Mode.
If you can't get into Safe Mode, try using System Restore from your installation DVD to set the system back to the previous restore point that you created.
I am a bit confused here. Memtest told me there were no errors. It ran over night for approximately 10 hours.
As far as driver verifier is concerned, I am completely lost. I did everything that was in your tutorial step by step, waited for crash, even checked that it was enabled afret reboot (I looked at verifier -> display settings). Then I posted the one dmp it produced. If it says my verifier was off, maybe there is a super secret option somewhere to enable dumps with verifier?
When I type verifier /query, the terminal just pops and disappears right away, so I cannot read it. But I guess that it should tell me the same thing as the display existing settings option in the gui...
Anyway, I am going to try again now
I got this... If it is not enabled now, then I really will cry