BSOD since istallation of SWTOR

Page 1 of 2 12 LastLast

  1. RDM
    Posts : 8
    Windows 7 Ultimate x64
       #1

    BSOD since istallation of SWTOR


    Hi,

    Since installing Star Wars The Old Republic I have been getting quite a few BSOD. Mainly with Memory_Management errors. The system has been running fine before that.

    System will run happily until I start SWTOR which will then eventually crash, or the system will crash soon after I exit it.

    Attached is all the information as requested, thanks in advance for any help!
      My Computer


  2. Posts : 28,845
    Win 8 Release candidate 8400
       #2

    RDM said:
    Hi,

    Since installing Star Wars The Old Republic I have been getting quite a few BSOD. Mainly with Memory_Management errors. The system has been running fine before that.

    System will run happily until I start SWTOR which will then eventually crash, or the system will crash soon after I exit it.

    Attached is all the information as requested, thanks in advance for any help!

    These crashes were caused by memory corruption (probably a driver). Please run these two tests to verify your memory and find which driver is causing the problem.

    If you are overclocking anything reset to default before running these tests.
    In other words STOP!!!



    1-Memtest.
    *Download a copy of Memtest86 and burn the ISO to a CD using Iso Recorder or another ISO burning program. Memtest86+ - Advanced Memory Diagnostic Tool

    *Boot from the CD, and leave it running for at least 5 or 6 passes.

    Just remember, any time Memtest reports errors, it can be either bad RAM or a bad motherboard slot.

    Test the sticks individually, and if you find a good one, test it in all slots.

    Any errors are indicative of a memory problem.

    If a known good stick fails in a motherboard slot it is probably the slot.

    RAM - Test with Memtest86+



    2-Driver verifier

    Using Driver Verifier is an iffy proposition. Most times it'll crash and it'll tell you what the driver is. But sometimes it'll crash and won't tell you the driver. Other times it'll crash before you can log in to Windows. If you can't get to Safe Mode, then you'll have to resort to offline editing of the registry to disable Driver Verifier.

    I'd suggest that you first backup your data and then make sure you've got access to another computer so you can contact us if problems arise. Then make a System Restore point (so you can restore the system using the Vista/Win7 Startup Repair feature).

    In Windows 7 you can make a Startup Repair disk by going to Start....All Programs...Maintenance...Create a System Repair Disc - with Windows Vista you'll have to use your installation disk or the "Repair your computer" option at the top of the Safe Mode menu .

    Then, here's the procedure:
    - Go to Start and type in "verifier" (without the quotes) and press Enter
    - Select "Create custom settings (for code developers)" and click "Next"
    - Select "Select individual settings from a full list" and click "Next"
    - Select everything EXCEPT FOR "Low Resource Simulation" and click "Next"
    - Select "Select driver names from a list" and click "Next"
    Then select all drivers NOT provided by Microsoft and click "Next"
    - Select "Finish" on the next page.

    Reboot the system and wait for it to crash to the Blue Screen. Continue to use your system normally, and if you know what causes the crash, do that repeatedly. The objective here is to get the system to crash because Driver Verifier is stressing the drivers out. If it doesn't crash for you, then let it run for at least 36 hours of continuous operation (an estimate on my part).

    If you can't get into Windows because it crashes too soon, try it in Safe Mode.
    If you can't get into Safe Mode, try using System Restore from your installation DVD to set the system back to the previous restore point that you created.
    Driver Verifier - Enable and Disable


    Further Reading
    Using Driver Verifier to identify issues with Windows drivers for advanced users
      My Computer


  3. RDM
    Posts : 8
    Windows 7 Ultimate x64
    Thread Starter
       #3

    Thanks for that zigzag3143.

    With verifier running according to your instructions windows lasted a full 10 seconds after log in before crashing with a Driver_Verifier_Detected_Violation. Both times on ASACPI.sys.

    Is this likely to be my culprit? If so, how do I go about making it better?
      My Computer


  4. Posts : 28,845
    Win 8 Release candidate 8400
       #4

    RDM said:
    Thanks for that zigzag3143.

    With verifier running according to your instructions windows lasted a full 10 seconds after log in before crashing with a Driver_Verifier_Detected_Violation. Both times on ASACPI.sys.

    Is this likely to be my culprit? If so, how do I go about making it better?

    Asacpi.sys is a HUGE cause of BSOD's
    You should also turn verifier off.

    Asacpi.sys

    The pre 2009 version of this driver is a known bsod cause.
    Please visit this link: Asus tek computer inc. -support- drivers and download p7p55d le

    ASUSTeK Computer Inc. -Support- Drivers and Download P7P55D LE
    ASUSTeK Computer Inc. - Motherboards- ASUS P5K-VM

    Scroll down to the utilities category, then scroll down to the "atk0110 driver for windowsxp/vista/windows 7 32&64-bit" (it's about the 12th item down).

    Download and install it.

    Go to c:\windows\system32\drivers to check and make sure that the asacpi.sys file is date stamped from 2009 or 2010 (notbefore).
      My Computer


  5. Posts : 3,139
    Systems 1 and 2: Windows 7 Enterprise x64, Win 8 Developer
       #5

    It's an ACPI utility. Go to AsusTek and find the latest driver for this. I don't know if you have Rampage II Extreme or Rampage II Gene
      My Computer


  6. RDM
    Posts : 8
    Windows 7 Ultimate x64
    Thread Starter
       #6

    Booted into Safe Mode and turned verifier off.

    Asus Rampage II Extreme (they really need to come up with some slightly less geeky names...). Followed the advice and downloaded the 2009 version of the driver (the previous one seems to have been a 2005 one). Will give SWTOR and blast and see if this has solved my issues.

    Thanks for all the help!
      My Computer


  7. Posts : 28,845
    Win 8 Release candidate 8400
       #7

    RDM said:
    Booted into Safe Mode and turned verifier off.

    Asus Rampage II Extreme (they really need to come up with some slightly less geeky names...). Followed the advice and downloaded the 2009 version of the driver (the previous one seems to have been a 2005 one). Will give SWTOR and blast and see if this has solved my issues.

    Thanks for all the help!
    If you had the 2005 version I am sure the 2009 will fix it.
      My Computer


  8. RDM
    Posts : 8
    Windows 7 Ultimate x64
    Thread Starter
       #8

    So far so good, system seems to be relatively stable with no crashes. Will give it a day or two before marking as solved just to make sure.

    Thanks a lot for your help zigzag.
      My Computer


  9. Posts : 28,845
    Win 8 Release candidate 8400
       #9

    RDM said:
    So far so good, system seems to be relatively stable with no crashes. Will give it a day or two before marking as solved just to make sure.

    Thanks a lot for your help zigzag.
    My pleasure and good luck
      My Computer


  10. RDM
    Posts : 8
    Windows 7 Ultimate x64
    Thread Starter
       #10

    Spoke too soon. System is certainly more stable but SWTOR will still cause it to crash if I try and use it more than once or for an extended period of time. However it gave me a different BSOD, this time BAD_POOL_HEADER. Will try the dirver verifier again and have attached the dmp file.
      My Computer


 
Page 1 of 2 12 LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 15:33.
Find Us