New Build and got a BSOD after doing windows update

There is a known issue with some AMD CPU Integrated Memory Controllers (IMC) that have BSoDs when running RAM above 1333MHz.

For testing purposes manually set your RAM frequency to 1333MHZ (may be 666MHZ in your BIOS), RAM timings to 9-9-9-24, leave the rest on auto, and the 'Command Rate' to 2T.
Save and Exit your BIOS.

Go to your BIOS and tell us what the CPU, RAM and the CPU integrated memory controller voltages are.
Look for DRAM and CPU VTT voltages.
In your next post tell us these voltages.

It's the CPU/NB voltage, the CPU integrated memory controller voltage.

With 8GB RAM the DRAM and CPU/NB voltage might need a small bump.

Most CPUs will need a CPU-NB Voltage boost of +0.10V, so if your default is 1.10V, set it to 1.20V.

It's not the NB voltage.

It's CPU/NB voltage, See page 3-7 and 3-12 of your ASUSTek M5A97 motherboard manual.

See my last post, for voltage setting for the CPU/NB voltage.

Change the CPU & NB Voltage from [Offset mode] to [Manual mode].
Then set the CPU/NB voltage to +0.10V of the current setting, so if your default is 1.10V, set it to 1.20V.

Post the full set of cash files if you get another one.
We need these to analyze the BSoDs.

Yes change the CPU/NB Manual Voltage to 1.225V.
Check for stability.
If you get another crash, post the dump files and other supporting files.

See if this runs stable, it should.
If not, then another CPU/NB voltage bump to 1.300v.
That RAM should run stable at DRAM 1.500v, we'll see after the CPU/NB bump to 1.225v.

You're Welcome.