Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: BSOD When Gaming BCCode 50 PAGE_FAULT_IN_NONPAGED_AREA

12 Feb 2012   #31
Nick05

Windows 7 Home Premium 64bit
 
 

okee, will post back if any problems persist ....


My System SpecsSystem Spec
.
12 Feb 2012   #32
Nick05

Windows 7 Home Premium 64bit
 
 

Hopefully i am not speaking too soon but not a single glitch so far .....
My System SpecsSystem Spec
12 Feb 2012   #33
writhziden

Windows 7 Home Premium 64 Bit
 
 

Keep doing your normal routine for a while. If you do not crash with the headset removed, re-install it, see if it causes crashes again. May have just been corrupted drivers. If it causes crashes again, replace it with a mic/headphone jack dual headset.
My System SpecsSystem Spec
.

16 Feb 2012   #34
Nick05

Windows 7 Home Premium 64bit
 
 

I really am starting to fear the worst, multiple BCCode 50 BSOD's.....

Nick.
My System SpecsSystem Spec
16 Feb 2012   #35
writhziden

Windows 7 Home Premium 64 Bit
 
 

I take it this was with the headset removed? I still see its drivers loaded...

Regardless, the 50 crash is related to your graphics card, but since you replaced the bad card, we should look at RAM as a possible culprit. Bug Check 0x50: PAGE_FAULT_IN_NONPAGED_AREA contains resolutions to the problem:

Quote:
Resolving a faulty hardware problem: If hardware has been added to the system recently, remove it to see if the error recurs. If existing hardware has failed, remove or replace the faulty component. You should run hardware diagnostics supplied by the system manufacturer. For details on these procedures, see the owner's manual for your computer.

Resolving a faulty system service problem: Disable the service and confirm that this resolves the error. If so, contact the manufacturer of the system service about a possible update. If the error occurs during system startup, restart your computer, and press F8 at the character-mode menu that displays the operating system choices. At the resulting Windows Advanced Options menu, choose the Last Known Good Configuration option. This option is most effective when only one driver or service is added at a time.

Resolving an antivirus software problem: Disable the program and confirm that this resolves the error. If it does, contact the manufacturer of the program about a possible update.

Resolving a corrupted NTFS volume problem: Run Chkdsk /f /r to detect and repair disk errors. You must restart the system before the disk scan begins on a system partition. If the hard disk is SCSI, check for problems between the SCSI controller and the disk.
Finally, check the System Log in Event Viewer for additional error messages that might help pinpoint the device or driver that is causing the error. Disabling memory caching of the BIOS might also resolve it.


Additionally:
Run the boot version of Memtest86+ paying close attention to Parts 2 and 3 of the tutorial. Also, in case Memtest86+ misses anything and comes up with no errors, run the extended version of the Windows Memory Diagnostics Tool for at least five passes. These you may want to run overnight since they take a long time to complete (run them an hour before bed each of the next two nights and check before going to sleep that they are still running).

If you swap any memory components, follow these steps for ESD safety:
  1. Shut down and turn off your computer.
  2. Unplug all power supplies to the computer (AC Power then battery for laptops, AC power for desktops)
  3. Hold down the power button for 30 seconds to close the circuit and ensure all power drains from components.
  4. Make sure you are grounded by using proper grounding techniques, i.e. work on an anti-static workbench, anti-static desk, or an anti-static pad. Hold something metallic while touching it to the anti-static surface, or use an anti-static wristband to attach to the anti-static material while working.
Once these steps have been followed, it is safe to remove and replace components within your computer.
My System SpecsSystem Spec
16 Feb 2012   #36
Nick05

Windows 7 Home Premium 64bit
 
 

Headset removed but admittedly i forgot to uninstall drivers.....

Currently running a chk dsk and will run memtest overnight....

Could this have anything to do with a faulty MOBO or PSU ? the reason i ask is this will be the 2nd replacement card (third card) i basically had one card go faulty so that was replaced although the second card they sent me was not brand new, then that card went faulty which I put down to the fact that they sent me a refurbished card that didn't last long so they then sent me my third card which is brand new and now it looks like that's going wrong too.
My System SpecsSystem Spec
16 Feb 2012   #37
writhziden

Windows 7 Home Premium 64 Bit
 
 

Do you know anyone with a comparable PSU you could swap with to see if it resolves the problem? It could very well be bad slots in the motherboard or a faulty PSU, but you need to test each to determine which it is.

It could also be memory based since that is one of the first things that causes the 0x50 bugcheck.
My System SpecsSystem Spec
17 Feb 2012   #38
Nick05

Windows 7 Home Premium 64bit
 
 

Good Morning writhziden

I have run a successful Chkdsk /f /r with 0 problems and also ran memtest for 7hrs 45mins also with 0 errors.
My System SpecsSystem Spec
17 Feb 2012   #39
writhziden

Windows 7 Home Premium 64 Bit
 
 

Download and install CPUZ and Upload screenshots of the CPU, Mainboard, Memory, and SPD tabs.

Also, go into your BIOS and post all RAM and CPU Voltages and all RAM settings (timings, frequency, etc.)

Thanks to Dave76 for help learning RAM Stability
My System SpecsSystem Spec
17 Feb 2012   #40
Nick05

Windows 7 Home Premium 64bit
 
 

As requested....

P.S I have now removed the second card though fear of losing another one.
My System SpecsSystem Spec
Reply

 BSOD When Gaming BCCode 50 PAGE_FAULT_IN_NONPAGED_AREA




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
BSOD Error PAGE_FAULT_IN_NONPAGED_AREA BCCode: 50
I am helping a friend with this problem where all the sudden he is getting the BSOD Error PAGE_FAULT_IN_NONPAGED_AREA BCCode: 50. I have tried many many things and nothing seems to work. I have tried to boot into safe mode and it gets to a point and just reboots. I have also tried different...
BSOD Help and Support
BSOD BCCODE 116 browsing, gaming
Frequent blue screen errors. Image just freezes and a sound loops. I never see the blue screen, save for a few crash dump errors. Any help would be appreciated. GPU: 670 Problem signature: Problem Event Name: BlueScreen OS Version: 6.1.7600.2.0.0.256.1 Locale ID: 1033 Additional...
BSOD Help and Support
BSOD when Gaming PAGE_FAULT_IN_NONPAGED_AREA
Hey Forums, I am hoping to get advice on how to fix the BSOD: PAGE_FAULT_IN_NONPAGED_AREA. This BSOD only occurs when gaming, most recently Borderlands 2, CoJ: Gunslinger, and Killing Floor. My GPU has the latest drivers, and I've ran Memtest for 4 hours with no problems.
BSOD Help and Support
BSOD When Normal Web browsing or gaming, BCCode 101
Okay, so I decided to clean out my PC from dust and what not only to come across a problem. (I reapplied thermal paste to the CPU as well.) However to make things more complicated, before I cleaned it all out, I had trouble with an update. On June 14 late night I shut down my PC to be met with an...
Performance & Maintenance
BSOD when gaming/transferring files - Page_Fault_In_NonPaged_Area
Getting this BSOD error above whenever I game or do a long file transfer. I can play usually about 30 minute to an hour before the error occurs. This is a new build, about 4 days old. I tried multiple fixes, but I can't find what is causing the issue, and I'm getting really annoyed at this point....
BSOD Help and Support
BSoD from just gaming to browsing, BCCode: 116
Hi, been crashing with increasing frequency for a few months now. All I see is a black screen with the sound on a short, never-ending loop, but after rebooting, windows reports it as a blue screen. BCCode 116, so I thoroughly purged the comp of dust, and have monitored both the GPU and CPU...
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 23:48.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App