|28 Apr 2012||#1|
| || |
Win7 Stuck/Restart/kernel-power 41
Hello, first of all I will note that I'm currently in SAFE MODE with NETWORK Because my cp is not holding me over a few minutes until It stuck or reboot, without blue screens even though I took the check to restart automataic when an error apply ...
My spec:Windows 7, ACER ASPIRE X1700
ATI card READON HD3500/4000
After I dug in various forums in the world with similar problems could not fix it. I've had problems with blue in the last year screens ,What I did was I unpacked the computer, I replaced the glue / paste special under the fan and put him back somehow only this helped and the computer was good without reboots until recently.
In the Events diary its shows critical errors KERNEL-POWER 41 after searching in the net I try some solutions:
Updates of Windows update + Drivers
I checked memories, cleaned dust, heat checking and some solutions that I do not remember, anyway nothing work and i'm hopeless .... I checked with the BLUESCREENVIEW Tool DUMP files and there is nothing from the past year. I working on the SAFE MODE NETWORKING almost an our and its works fine ... but of course it's not a solution ...
I join the files from thr instrucations but please notice that the dump files old.
... If you need me to upload something or tell more more please ask, thanks :]
little update after been in safe mode with network almost 2 hours its reboot ...
|My System Specs|
|29 Apr 2012||#4|
| || |
The fact that you are getting crashes in safe mode indicates hardware as the most likely cause.
To rule out BIOS corruption, you may also want to clear the CMOS. How To Clear CMOS (Reset BIOS)
Strip down your system to run only the bare essentials: one RAM module, the CPU, motherboard, hard disk, graphics card (or use onboard graphics if you have it), keyboard, mouse, and monitor. See how the system behaves by running Windows for twice as long as it typically takes for you to get a crash. If it is stable, add one piece of hardware back at a time until you get crashes again. Take notes of what hardware you add and how the system responds to the hardware changes.
As you add and remove hardware, follow these steps for ESD safety:
|My System Specs|
|Similar help and support threads for2: Win7 Stuck/Restart/kernel-power 41|
|Computer shuts down like power outtage, Kernel Power Error ID 41||BSOD Help and Support|
|One initial Install Restart, Windows gets stuck in a restart loop||Installation & Setup|
|Random Restart, No BSOD: Kernel-Power 41 in Event viewer||BSOD Help and Support|
|Kernel Power 41 on Win7 64bit||BSOD Help and Support|
|Getting daily BSOD in WIN7 machine, EventID: 41 Source: Kernel-Power||BSOD Help and Support|
|BSOD/Restart at random - Kernel-Power (41)||BSOD Help and Support|
|BSOD - Win7 - Kernel-Power||BSOD Help and Support|