Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Continual BSOD in Win 7 but will operate in Safe Mode with networking

26 May 2012   #1
Saul2Paul

Win 7 Home Premium 64
 
 
Continual BSOD in Win 7 but will operate in Safe Mode with networking

I have ran the BSOD Dump & System File Collection app with the results attached.
I attempted to run PERFMON report but was unsuccessful (Error: cannot find specified path).

I am running Win7 Home Premium (64 bit) and this is the original OS that was preinstalled with my laptop (ASUS G60VX). The system is approximately 2.5 years old and I have never re-installed the OS.

I continuously run system mechanic to monitor and clean out the drive and also use Norton 360 to supplement system mechanic. The system was gradually slowing down and occassionally freezing up. I upgraded the CPU with a T9600 chip and the system seemed to run fine but the temps definitely increased (fan constantly running but rpms varying with temps); I use SpeedFan to monitor temps. The lagging once again started so I had a deep scan and repair of the hard drive performed; took all night to run. This was done approximately one week ago. The system afterward now continually shuts down (BSODs) with no rhyme or reason. I do not know if it is hardware (GPU or hard drive) or software. I have re-installed the original CPU to see if this was the problem but the BSODs continue.

I am capable of operating in Windows Safe Mode with Networking.

I am relatively computer illiterate and really have no idea what I am doing...any assistance is appreciated. Thanks.


My System SpecsSystem Spec
.
26 May 2012   #2
ripbox

Windows 7 Home Premium x64 SP1
 
 

Sorry I didnt even look at the dump but i can tell you that system mechanic is your problem, if you can boot in safe mode then you may be able to enter windows and do a system restore back to before you did the scan (usually F2, F8 or F12 dependant of your system)
If you manage to do boot into safe mode and successfully restore then immediately remove System Mechanic and also Norton 360... these 2 so call programs are more harmful than good
In failing that you can not gain a restore then you will have to resort to a system repair, its best if you can borrow a windows disc from someone or if not then you may download the correct ISO form here Download Windows 7 ISO (Official 32-bit and 64-bit Direct Download Links) My Digital Life
I hope that this info is most helpful to you
My System SpecsSystem Spec
26 May 2012   #3
carwiz

Windows 7 Pro-x64
 
 

There were no dump files in your download but I gleaned the following from the logs.

The computer has rebooted from a bugcheck. The bugcheck was: 0x00000024 (0x00000000001904fb, 0xfffff8800cec8508, 0xfffff8800cec7d60, 0xfffff88001494380). A dump was saved in: C:\Windows\MEMORY.DMP. Report Id: 052512-41855-01.

Bugcheck code 24 has to do with NTFS file system corruption. It might be a good idea to run chkdisk before attempting to repair missing or corrupt drivers. Run Chkdsk /f /r to detect and resolve any file system structural corruption. You must restart the system before the disk scan begins on a system partition. Follow the tutorial here: Disk Check

If the file system can be recovered, run spf /scannow following this tutorial and using Option 2:
SFC /SCANNOW Command - System File Checker

The file corruption may be the cause of several drivers failing to load and start too. This was also in the log:
The following boot-start or system-start driver(s) failed to load:
BHDrvx64
ccHP
discache
eeCtrl
ElRawDisk
IDSVia64
spldr
SRTSPX
SymIRON
SYMTDIv
Wanarpv6

The computer has rebooted from a bugcheck. The bugcheck was: 0x0000003b (0x00000000c0000005, 0xfffff800030355e5, 0xfffff8800c05ad60, 0x0000000000000000). A dump was saved in: C:\Windows\MEMORY.DMP. Report Id: 052612-25194-01.

The SYSTEM_SERVICE_EXCEPTION bugcheck has a value of 0x0000003B. This is usually caused by bad or corrupt drivers.
My System SpecsSystem Spec
.

Reply

 Continual BSOD in Win 7 but will operate in Safe Mode with networking




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
Browsers working in safe mode with networking but not in normal mode
Hi , I'm using windows7 32-bit operating system. I have internet explorer 8( it never worked since installation, always shows "No network connection") and Google chrome installed in my computer. I had been using Google chrome which crashed yesterday. I re-installed Chrome and now it says...
Browsers & Mail
No internet in normal mode but works in safe mode with networking
Hi! I'm just a new here, hope someone can help and give advice here. (Sorry if this is not the right thread to start my topic) Scenario: (this is my first time to encounter this problem) While playing facebook games last monday, my computer get BSOD and restarts. After booting up on windows,...
Network & Sharing
No wireless signal unless in safe mode with networking
So I've got a XPS 14z (XPS L412Z) with Windows 7 Home Premium 64 on it. Suddenly, the wireless couldn't get a signal unless a few feet from the router. In safe mode with networking, it works perfectly, so I figured it was a software issue. Tried a system restore to a week ago, tried searching...
Network & Sharing
No Internet Access, except Safe Mode with Networking
Hello, I am a PC tech, and I have gotten 3 laptops with the same issue this week. All unrelated, and the first 2 I just formatted to fix the issue, but now I would like to get to the bottom of this. I have gone ahead and ran HijackThis.exe. Here is my log file. I know its gotta be a service or a...
Network & Sharing
Cannot access Safe Mode but can boot in Safe Mode with Networking
After attempting to start my Laptop in Safe Mode, it loaded drivers normally only to crash a few seconds later. A prompt message appears but is impossible to read because Windows immediately reboots upon showing the prompt. Safe Mode with Networking loads normally. Any ideas or advice? The...
BSOD Help and Support
Black screen, safe mode, no networking
I am experiencing the black screen issues with my new windows 7 lenovo laptop. when it starts normally, I can get to my user logon screen but when I select a profile the computer takes a moment to load through the welcome... part and then just a faint light blue screen with cursor. In normal mode I...
General Discussion


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 21:02.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App