Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: BSOD shortly after start up, 0x0000001e

05 Jun 2012   #11
ivNKj

Windows 7 Ultimate x64
 
 

I've uninstalled ESET and replaced it with MSE. I haven't reinstalled/upgraded any drivers yet. The system specs are filled in. Here are the CPU-Z tabs:

http://i46.tinypic.com/qpgv9h.jpg

BIOS settings:

CPU Vcore 1.26875V [Auto]
QPI/Vtt Voltage 1.100V [Auto]
PCH Core 1.050V [Auto]
CPU PLL 1.800V [Auto]
DRAM Voltage 1.500V [Auto]


I can see the actual used voltages for only DRAM and CPU Vcore from BIOS which are:
Vcore 1.232 V
DRAM Voltage 1.584V

Frequencies:
BLCK 133.28 Mhz
CPU Frequency 2.798.99 Mhz
Memory Frequency 1332.69 Mhz

Memory timings:
9-9-9-24

I've also lately noticed that it takes my PC around 10 seconds to establish the internet connection when I log in to the system instead of instantly. This weird delay doesn't really cause me much issues since its duration is so little but I wonder if it's related to this?


My System SpecsSystem Spec
.
05 Jun 2012   #12
writhziden

Windows 7 Home Premium 64 Bit
 
 

Quite possibly related to your problem. May be that your network drivers are corrupted or need updating. Thank you for the memory information. We will look into that further if the driver updates do not resolve the crashes.
My System SpecsSystem Spec
06 Jun 2012   #13
ivNKj

Windows 7 Ultimate x64
 
 

I have reinstalled all the drivers for the mentioned devices (I checked from the motherboard manufacturer's website that they're the latest version). I still have that ~10 sec delay in establising internet connection when logging into the system and most likely still get those errors in Memtest86 (haven't ran it yet after reinstalling the drivers).

Here is screenshot of what the internet connection error looks like to me when I open Chrome right after logging in and it tries to open the tabs of the previous session:

http://i47.tinypic.com/xq49x.png

Here is what it says if I try to refresh one of those pages when the connection is still off:

http://i50.tinypic.com/2yzaivl.png
My System SpecsSystem Spec
.

07 Jun 2012   #14
writhziden

Windows 7 Home Premium 64 Bit
 
 

Strange. I am wondering if a Repair Install is needed.
My System SpecsSystem Spec
07 Jun 2012   #15
ivNKj

Windows 7 Ultimate x64
 
 

I ran it once and it said:

Windows Resource Protection did not find any integrity violations.

I also noticed yet another small glitch. If I drag a window with a fullscreened window on the background, for example Google Chrome or Paint, the dragged window leaves a trail of its edges. Here is a screenshot:

http://i49.tinypic.com/2ebycjr.jpg
My System SpecsSystem Spec
07 Jun 2012   #16
Outlander

W7x64 Ult.
 
 

I had odd things like this not long ago and it kind of looks like I was bitten by the Sandforce bug. Better check your SSD controller and if it is an early Sandforce start backing up NOW!
My System SpecsSystem Spec
07 Jun 2012   #17
ivNKj

Windows 7 Ultimate x64
 
 

Quote   Quote: Originally Posted by Outlander View Post
I had odd things like this not long ago and it kind of looks like I was bitten by the Sandforce bug. Better check your SSD controller and if it is an early Sandforce start backing up NOW!
Well I just found out that the windows leaving trails when dragged only happens with the classic Windows theme, with Aero enabled it doesn't happen so I'm not sure what is causing it. How do I check if my SSD uses an early SandForce?
My System SpecsSystem Spec
07 Jun 2012   #18
Outlander

W7x64 Ult.
 
 

Google the Model of your SSD and see if you can find the spec's? Then check for controller #/type and Google that to see if it is one of the early model Sandforce units. Having gone through a similar experience your situation makes me feel uneasy. I would back up everything of value ASAP! Hopefully you do not have one of the problematic controllers.
My System SpecsSystem Spec
07 Jun 2012   #19
ivNKj

Windows 7 Ultimate x64
 
 

Well after some googling I'm fairly sure my Intel X-25M is not a SandForce using SSD. Atleast most of the topics I found were along the lines of "Intel or SandForce?". Official specs in Intel's website say nothing about SandForce.
My System SpecsSystem Spec
08 Jun 2012   #20
writhziden

Windows 7 Home Premium 64 Bit
 
 

Try doing a power cycle of the SSD. The following steps should be carried out and take ~1 hour to complete.
  1. Power off the system.
  2. Remove all power supplies (ac adapter then battery for laptop, ac adapter for desktop)
  3. Hold down the power button for 30 seconds to close the circuit and drain all components of power.
  4. Reconnect all power supplies (battery then ac adapter for laptop, ac adapter for desktop)
  5. Turn on the system and enter the BIOS (see your manual for the steps to enter the BIOS)
  6. Let the computer remain in the BIOS for 20 minutes.
  7. Follow steps 1-3 and physically remove the SSD from the system by disconnecting the cables for a desktop or disconnecting the drive from the junction for a laptop.
  8. Leave the drive disconnected for 30 seconds to let all power drain from it.
  9. Replace the drive connection(s) and then do steps 4-8 again.
  10. Repeat steps 1-4.
  11. Start your computer normally and run Windows.

The above steps were a result of: Why did my SSD "disappear" from my system? - Crucial Community

While that may not be your drive, a power cycle should be the same on all SSD drives. See how the system responds after the SSD power cycle.
My System SpecsSystem Spec
Reply

 BSOD shortly after start up, 0x0000001e




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
BSOD shortly after start up, Bugcheck code: 0x1E (0xFFFFFFFFC0000005,
Hello, I have a Toshiba laptop that started with the BSOD right after a virus that was removed, not sure if related. Here is my who crashed copied and pasted. Not sure how to do a zip file of my minidump. :o System Information (local) </B> computer name: OD-PC windows version: Windows 7...
BSOD Help and Support
BSOD whenever I start up, error 0x0000001E
Whenever I try to start up my computer, I will be able to use it for a few minutes then it will get the BSOD. It works fine when I use safe-mode though (I am using safe-mode right now too). It gets the BSOD whenever I try to use the "normal" mode I guess. I also used the SF diagnostic tool in...
BSOD Help and Support
BSOD every start up, error 0x0000001E
Hi all, I have an HP Pavilion dv7 that BSOD every time I start up. Start up is extremely slow, and once I get to my desktop I get about 5 minutes before BSOD and shut down. When I ran a system scan, no integrity issues were found. I have attached the dump files. One last thing I noticed is that...
BSOD Help and Support
BSOD on start up, error 0x0000001E
Hello everyone, as the title states upon startup of my Dell inspiron 620 I recieve a BSOD after loggin into my account. the stop shows 0x0000001E I am largely computer illiterate, so ill do my best at providing the needed information, however if I have missed something please let me know. ...
BSOD Help and Support
BSOD a little bit after start up. STOP: 0X0000001E
My computer overall has been so weird lately 1. It started to reset instead of shutting off for a while. 2. Then it did not wanna turn back on after it went to hibernate, it turned on and it turned off right away, it restarted till i held down the power button. I disabled hibernate 3. At one...
BSOD Help and Support
BSOD shortly after start up 75% of time
Hi, I'm running Windows 7 Ultimate x64. Service Pack 1, AMD Phenom 9650 Quad Core processor 2.30 GHz with 8 GB RAM. I get the BSOD roughly 75% of the time shortly after I start and log on to my system. Sometimes it happens within seconds of logon, sometimes within a few minutes after I start...
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 12:56.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App