Help with BSOD please don't know problem.


  1. Posts : 1
    windows 7 ultimate 64bit
       #1

    Help with BSOD please don't know problem.


    Here's my minidump files and etc.

    My computer will run perfectly fine, and then suddenly, not when running any specific application, starts to freeze up and then BSOD. No idea what's causing it and I would appreciate any help.
    Last edited by zack317; 15 Jun 2012 at 09:08.
      My Computer


  2. Posts : 11,269
    Windows 7 Home Premium 64 Bit
       #2

    You have a wide variety of crashes. That usually indicates a hardware issue. Run some hardware checks.
    • If you are overclocking any hardware, please stop.

    • If you have an SSD, make sure the following are up to date:
      • SSD firmware
      • BIOS Version
      • Chipset Drivers
      • Hard disk controller drivers/SATA drivers
      • If you have a Marvell IDE ATA/ATAPI device, make sure the drivers are up to date from the Intel site or Marvell site and not from your motherboard/vendor support site.


    • Run all but the advanced tests with SeaTools for HDDs.
    • Monitor temperatures during the following tests.
      Use the following programs to monitor the temperatures.


    • Run the boot version of Memtest86+ paying close attention to Parts 2 and 3 of the tutorial. Also, in case Memtest86+ misses anything and comes up with no errors, run the extended version of the Windows Memory Diagnostics Tool for at least five passes. These you may want to run overnight since they take a long time to complete (run them an hour before bed each of the next two nights and check before going to sleep that they are still running).

         Warning
      Before you proceed with the following, answer these two questions: Are you still under warranty? Does your warranty allow you to open up the machine to check hardware? If you are unsure of the answers to these questions, contact your system manufacturer. WARNING: The steps that follow can void your warranty!!!


      For Part 3: If You Have Errors: If you swap any memory components, follow these steps for ESD safety:
      1. Shut down and turn off your computer.
      2. Unplug all power supplies to the computer (AC Power then battery for laptops, AC power for desktops)
      3. Hold down the power button for 30 seconds to close the circuit and ensure all power drains from components.
      4. Make sure you are grounded by using proper grounding techniques, i.e. work on an anti-static workbench, anti-static desk, or an anti-static pad. Hold something metallic while touching it to the anti-static surface, or use an anti-static wristband to attach to the anti-static material while working. If you do not have an anti-static workbench, desk, or pad, you can use your computer tower/case by finding a metal hold in it, such as a drive bay.

      Once these steps have been followed, it is safe to remove and replace components within your computer.
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 13:28.
Find Us