Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Random BSOD after system maintenance

08 Oct 2012   #51
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

The core temps should be between 60-70C max.
Idle temps are much better .
This could be a CPU cooler fan problem, did you clean the cooling fins?


Take the PNY RAM out and run the CPU:OCCT test for 30 minutes, stop the test if the CPU goes over 80C, be sure to monitor your CPU and GPU temps closely.
Set the time before you start.
When its done, pass or fail, it will make some graphs. Post these here again.

You might want to consider a new CPU cooler.
I have used this one, it works very well and the price is good.
COOLER MASTER Hyper 212 Plus

Check the height of your RAM cards, a big heatsink on the RAM cards may contact the Hyper 212.
I had very little clearance with standard Corsair XMS cards.


My System SpecsSystem Spec
.
09 Oct 2012   #52
badkarma11

Windows 7 Ultimate x64 Full Retail SP1
 
 

The fan seems OK, I cleaned the fins a while back, still clean. THe PNY cards have heat sinks, the Crucial do not so I'll probably have to swap them if I get that cooler. I'll run the 30 minute test with what I've got and post results.

EDIT: Ran the CPU test, temps spiked after about a minute and a half and killed the test. I think I'll buy that cooler you recommended. Mine is pretty weak, comparitively speaking. When I get and install it, I'll report back. Thanks for hanging in there.
My System SpecsSystem Spec
09 Oct 2012   #53
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

You're welcome.
We'll get to the end of it soon, I hope.

Swapping the RAM cards should work, the Hyper 212 Plus cooler fan will only be over the first RAM slot from the CPU.

Let me know how the new cooler is performing.
My System SpecsSystem Spec
.

13 Oct 2012   #54
badkarma11

Windows 7 Ultimate x64 Full Retail SP1
 
 

ordered the new cooler finally. All last week (since I repasted my existing CPU cooler) the machine behaved flawlessly. No app crashes, no BSODs no matter what I was doing. This morning it went back to hell. I had returned the NB and DRAM voltages to stock settings after I repasted and have not touched them since. dump attached, for your amusement.
My System SpecsSystem Spec
14 Oct 2012   #55
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

Change the DRAM voltage to 1.600v and the NB voltage to 1.220v.

Which RAM cards do you have installed now?
Can you let me know which RAM is installed on each reply?
You need to check if the Crucial or PNY is faulty, so run them separately, if you get a crash swap them.
One of the RAM cards may be faulty, the two sets may not run together stable, you may need to adjust the settings to get them to run together.
So test with either Crucial or PNY for now.

These crashes are from RAM issues, your last description confirms that is the most likely cause.
Last three crashes:
Code:
STOP 0x00000050: PAGE_FAULT_IN_NONPAGED_AREA 
Usual causes:  Defective hardware (particularly memory - but not just RAM), Faulty system service, Antivirus,  Device driver, NTFS corruption, BIOS 
GetUlongFromAddress: unable to read from fffff800030fa1c0 
FAILURE_BUCKET_ID:  X64_0x50_nt!CmpKcbCacheLookup+1de
-----------------------------------------------------------------------------------------------------------------------------------------------------
STOP 0x00000019: BAD_POOL_HEADER 
Usual causes:  Device driver
Probably caused by : Pool_Corruption ( nt!ExDeferredFreePool+118b )
PROCESS_NAME:  WerFault.exe
IMAGE_NAME:  Pool_Corruption
FAILURE_BUCKET_ID:  X64_0x19_3_nt!ExDeferredFreePool+118b
-----------------------------------------------------------------------------------------------------------------------------------------------------
STOP 0x0000004E: PFN_LIST_CORRUPT
Usual causes:  Device driver, ?memory
Probably caused by : memory_corruption ( nt!MiBadShareCount+4c )
IMAGE_NAME:  memory_corruption
FAILURE_BUCKET_ID:  X64_0x4E_99_nt!MiBadShareCount+4c
My System SpecsSystem Spec
14 Oct 2012   #56
badkarma11

Windows 7 Ultimate x64 Full Retail SP1
 
 

I currently have the PNY in slots 1 and 3, and the crucial in the other 2. Before I repasted the cpu heat sink last week, I had run on only the PNY in slots one and three for the previous week. I had gotten crashes and you told me to run the OCCT tests. The system 'heat spikes' on either the CPU or power supply tests after 30 -90 seconds and OCCT ends the tests. Yesterday, after the system steadied down, I ran OCCT and then played some games and watched the CPU temps. They were topping out at 75-80 degrees under load (not good). There is obviously a heat issue, besides whatever else might be wrong with the RAM. I ordered the new cooler and when I crack the case to install that I will pull the PNY and run on the crucial. That way I can hopefully run the OCCT power supply and CPU tests and see if it's stable with the crucial alone. I will reset the DRAM and NB voltages to 1.60 and 1.20 respectively. I will report back when I have the new cooler installed and the PNY RAM removed. Thanks for your help and I apologize for not being clear in my last post.
My System SpecsSystem Spec
14 Oct 2012   #57
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

Thanks for the update.

It helps a lot if you can keep me advised to any changes you make on your system.
My System SpecsSystem Spec
17 Oct 2012   #58
badkarma11

Windows 7 Ultimate x64 Full Retail SP1
 
 

Yay cooler came! Boo, have to utterly disassemble the machine to install it. more to follow..
My System SpecsSystem Spec
17 Oct 2012   #59
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

Good news, let us know how the install goes.
My System SpecsSystem Spec
18 Oct 2012   #60
badkarma11

Windows 7 Ultimate x64 Full Retail SP1
 
 

I will. Probably won't get to it until the weekend but I'll update when it's in. I'll run the OCCT CPU and PSU tests and post the graphs after it's in and the PNY memory is out.
My System SpecsSystem Spec
Reply

 Random BSOD after system maintenance




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
System Maintenance Troubleshooter - Turn On or Off
How to Turn the "System Maintenance Troubleshooter" On or Off in Windows 7 The System Maintenance Troubleshooter automatically performs common maintenance tasks below weekly in Windows 7. It either fixes any found problems automatically, or reports the problems through Action Center. What...
Tutorials
What system maintenance software do you use?
Hundreds of system maintenance software out there for us to choose from. Popular ones seem to be CCleaner; Advanced SystemCare; Tuneup Utilities, etc. Just wondering are they really do what they are supposed to? How many of you have purchased one?
Software
User vs System-Wide Maintenance Question
I have several "users" on my Win 7 Home Premium 64-bit system. I'm not totally clear on which system maintenance items can be just run under the administrator account and will cover ALL users at once and which must be run for each user account individually. I have classified them the way I see it...
Performance & Maintenance
What programs do YOU use for system maintenance/optimization?
I am curious what programs (if you do) you use for system maintenance such as for cleaning "junk files", registry clean up, defragmentation, start up... to start the discussion: defraggler- defragmentation tuneup utilities- junk files, registry ccleaner- junk, registry revo uninstaller-...
Performance & Maintenance
System Maintenance Troubleshoot Shortcut - Create
How to Create a "System Maintenance Troubleshooter" Shortcut in Windows 7 This will show you how to create or download a Windows 7 System Maintenance Troubleshooter shortcut to use when you like.The System Maintenance Troubleshooter automatically performs common maintenance tasks below weekly...
Tutorials
Which Files Does Win 7 System Maintenance Tool Delete
Which Files Does the Windows 7 System Maintenance Tool Delete? Source - Which Files Does the Windows 7 System Maintenance Troubleshooter Delete? - The Winhelponline Blog
Performance & Maintenance


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 02:26.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App