Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Freezing - Kernel-Power 41- BSOD

14 Sep 2012   #1
Reddax

Windows 7 64 Bit
 
 
Freezing - Kernel-Power 41- BSOD

Hello, recently i've been getting strange freezes lasting around 10 minutes and ranging from 10minutes to 4 hours from boot then forcefully restarts, or sometimes i get a bsod saying "Kerl_Data_Inpage_error" and when i check up on my event viewer, it shows critical errors of Kernel-Power 41 that the computer unexpectedly shut down.
Is this software side or hardware side? I ran the memtest overnight and no errors were found.


My System SpecsSystem Spec
.
14 Sep 2012   #2
koolkat77

Microsoft Community Contributor Award Recipient

Windows 10 Home 64Bit
 
 

My System SpecsSystem Spec
15 Sep 2012   #3
Reddax

Windows 7 64 Bit
 
 

I've also swapped out my power supply and it's still doing it. Do i set the dump file to kernel or small memory dump? as i just got the bsod on kernel memory dump and the minidump folder doesn't exist
My System SpecsSystem Spec
.

15 Sep 2012   #4
koolkat77

Microsoft Community Contributor Award Recipient

Windows 10 Home 64Bit
 
 

My System SpecsSystem Spec
15 Sep 2012   #5
Reddax

Windows 7 64 Bit
 
 

Here you go
My System SpecsSystem Spec
15 Sep 2012   #6
koolkat77

Microsoft Community Contributor Award Recipient

Windows 10 Home 64Bit
 
 

Got it. Thanks.

STOP 0x0000007A: KERNEL_DATA_INPAGE_ERROR http://www.carrona.org/bsodindx.html#0x0000007A

Usual causes: Memory, Paging file corruption, File system, Hard drive, Cabling, Virus infection, Improperly seated cards, BIOS, Bad motherboard, Missing Service Pack.

Code:
*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck 7A, {20, ffffffffc000009d, fffffa8008739078, 0}

Probably caused by : ntkrnlmp.exe ( nt! ?? ::FNODOBFM::`string'+4bed0 )

Followup: MachineOwner
---------

2: kd> !analyze -v
*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

KERNEL_DATA_INPAGE_ERROR (7a)
The requested page of kernel data could not be read in.  Typically caused by
a bad block in the paging file or disk controller error. Also see
KERNEL_STACK_INPAGE_ERROR.
If the error status is 0xC000000E, 0xC000009C, 0xC000009D or 0xC0000185,
it means the disk subsystem has experienced a failure.
If the error status is 0xC000009A, then it means the request failed because
a filesystem failed to make forward progress.
You can see "Missing Service Pack" in usual causes so before getting windows updates (incl. SP1), do the following tests:

To make sure that hard drive is good run disk check following this tutorial:
Disk Check
Hard drive scan usings SeaTools:
SeaTools | Seagate both long and short tests.
Run memtest86+ on each stick for 8 passes preferably overnight:
RAM - Test with Memtest86+
Uninstall Avast! and use MSE instead. Microsoft Security Essentials - Free Antivirus for Windows (For testing purpose, you may install avast back later.) and do a full scan once installed.

Check for an update on your BIOS from the manufacturers website.

Also recheck all the cable wiring etc.


Post back results
My System SpecsSystem Spec
15 Sep 2012   #7
Reddax

Windows 7 64 Bit
 
 

I've done the Disk check on my OS drive and it said no errors found, i'm unable to do the seatools as it says "Test unavailable" And i've already run the Memtest86 and no faults were found. When i leave my computer running, it seems to be fine, it's when i start to play games and internet browsers and stuff like that it Usually starts to do it, it isn't my graphics card as it happened before i replaced my graphics card, i've reinstalled windows numerous times to try to fix this problem yet it still does it. I have all my information backed up on my 1.5tb hard drive and windows on my 60gb ssd, could it be the ssd at fault? I've only had it for around 2 years
My System SpecsSystem Spec
15 Sep 2012   #8
koolkat77

Microsoft Community Contributor Award Recipient

Windows 10 Home 64Bit
 
 

Did you check the SSD firmware?
Run this, it will show the firmware version you have.
CrystalDiskInfo - Software - Crystal Dew World
My System SpecsSystem Spec
15 Sep 2012   #9
Reddax

Windows 7 64 Bit
 
 

I'm on 1.35 and i do believe there's a latest one for me which is 1.37. I have the Vertex 2. However my Health status of my 1.5tb is on caution and the reallocated sectors count is at 100, threshold is 36, does this mean this hard drive is dying or causing the freezes?
My System SpecsSystem Spec
15 Sep 2012   #10
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

Update the firmware on your Vertex2, these are known to have stability issues and the updated firmware should help.

Can you post a snip of the Crystal Disk info page?
How to Post a Screenshot in Seven Forums
Uninstall Seatools, download a new copy and install, try to run the Long Drive Self Test again.
If Seatools won't run on your drive it's a very bad sign.
Do you have all your data backed up?
If not, then just to be safe I would buy another hard drive and copy everything over to it while you can.
You should always keep Image Backups of your OS and data.
This could be the cause of your crashes, best to take precautions.

How many passes did you run with memtest86+?
My System SpecsSystem Spec
Reply

 Freezing - Kernel-Power 41- BSOD




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
Help Win 7, Freezing Crashing, Critical Kernel-Power Error
Intel Core 2 Quad Q9400 Gigabyte EP35-DS3 P35 Mainboard Palit GTS250 512MB DDR3 w/HDMI Kingston PC2-6400 DDR2 800 4GB Ram Integrated Gigabit /HD Sound Seasonic M12II-620W Plextor SSD 128BM WD 1TB Blue
BSOD Help and Support
Computer freezing often, kernel power error ID 41
I have had a problem for about a week and a half where my computer will freeze. I will be doing anything (playing WoW, browsing the internet, etc) and my monitor will enter power save mode, whatever sound that was playing will start to skip. At this point the computer is still on but completely...
General Discussion
WINDOWS 7 64-BIT kernel power critical error ID 41 FREEZING
I made a costum pc with my brother who has alot of experience. THIS IS A LONG STORY SO HOLD ON. i have this problem now for 2 years my computer just freezes up (or as ppl call locked-up). im freezing like hell replaced every part of my computer! and i mean everything.... i bought a PACK from my...
BSOD Help and Support
Yet another BSOD Kernel-power 41
- <Event xmlns="http://schemas.microsoft.com/win/2004/08/events/event"> - <System> <Provider Name="Microsoft-Windows-Kernel-Power" Guid="{331C3B3A-2005-44C2-AC5E-77220C37D6B4}" /> <EventID>41</EventID> <Version>2</Version> <Level>1</Level>
BSOD Help and Support
Kernel-Power BSoD
Hi, I've formatted my pc a few time over the last couple months but after the last time I have had two BSoDs. One happened while I was using XBMC and the other happened last night while I was updating my BFBC2 game, the two are about a week apart. *Critical Kernel-Power Event ID 41 Task...
BSOD Help and Support
BSOD/kernel power 41
Hello there i will cut to the chase...I bought a new custom build pc last week and from that time i am always getting the same errors/bsod.Its really random usually it crashes when i am opening the browser or not even doing a thing just being on dekstop please help me its really frustrating. this...
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 05:13.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App