Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: getting lots of bsod's, several different error codes.

18 Oct 2012   #21
centaur78

Windows 7 ultimate x64
 
 

Well not quite there.... one last thing you could do ... could you possibly post a snapshot of the SMART value of your HDD using crystal disk.

Crash dumps can also not be produced... if you have disk i/o errors or bad sectors


My System SpecsSystem Spec
.
18 Oct 2012   #22
garcey

windows 7 home premium 64 bit
 
 

Hello! I ran crystal disk, which says my HDD's status is good. However my computer did crash again just now and again no crash dumps. I'm gonna put the cystal disk report in a attachment because I feel like just copy/pasting it into the post would make the post a little to big.
My System SpecsSystem Spec
18 Oct 2012   #23
centaur78

Windows 7 ultimate x64
 
 

Please go to event viewer directly and right click on the system logs and syste, logs and save it as .evtx file as shown below and upload here

hereAttachment 237315
My System SpecsSystem Spec
.

22 Oct 2012   #24
garcey

windows 7 home premium 64 bit
 
 

I think this is the right file.
My System SpecsSystem Spec
06 Nov 2012   #25
garcey

windows 7 home premium 64 bit
 
 

Hello, What part do you think is most likely causing the problem? because right now I'm thinking to hell with fixing it I'll just replace what might be causing it and if that doesn't work I'll just buy a whole new computer. I'm tired of this this crashing all the time.
My System SpecsSystem Spec
06 Nov 2012   #26
centaur78

Windows 7 ultimate x64
 
 

Hi Garcey

sorry for not replying earlier.. was busy....

Ok here is the thing.... the eventviewer logs mostly refers to bugcheck errors 0x03b ... which could be caused either due to a faulty ram or the graphics driver.. since you have tested the ram for more 6 passes (i presume ) and found no errors.. as well as the SMART values of the HDD looks fine... we can at the moment rule out the hardwares. There were few errors due to DCOM, few related to network errors

We could either go ahead and uninstall software and drivers one by one through the safe mode and check for problem.....or I would rather suggest ... you do a clean install of Windows 7 ( after backing up your important stuff that is !!!) and then one by one installing only the drivers (make sure you don't install the suites that comes with these drivers) and see if you getting the same set of errors

If all this fails you could then go ahead with buying a new computer.... Till then please do bear with us
My System SpecsSystem Spec
17 Nov 2012   #27
garcey

windows 7 home premium 64 bit
 
 

Hello my computer died completely and won't start, so now I'm just buying more parts in the hopes that it will fix the problem since I have no clue as to what is the problem part. If you have any suggestions in that respect I only have this laptop for a little while.
My System SpecsSystem Spec
17 Nov 2012   #28
centaur78

Windows 7 ultimate x64
 
 

What do u mean it died ? Could you be more specific ?? Is there power coming to the motherboard ? Or does the motherboard lit up but won't start ?

Have you done what I have as asked you in the previous post?
My System SpecsSystem Spec
18 Nov 2012   #29
garcey

windows 7 home premium 64 bit
 
 

Hello when I say it won't start up I mean that when I press the power button it makes all the same noises as usual fans whurring an whatnot but nothing shows up on the screen. Everything seems to be getting power indeed I've even tried starting it with a different power supply. Actually I've replaced almost everything except for the mother board and the dvd thing.

As for what I've done in regards to your previous post I didn't get very far before it stopped working. I did decide to just re-install windows and after only installing a few drivers( video card,ethernet controller,and some realtek driver that I quite remember what was for) it crashed and wouldn't start up again. The computer not starting up again wasn't exactly out of the ordinary but this time I cannot get it to start up again at all, whereas previously it would fight me for awhile but eventually work. The only thing I did that might have had something to do with it other than the drivers, is that I changed the "write debugging information" setting from write kernel memory dump to write small memory dump( under the advanced page of system properties.

p.s. there is a green light on the motherboard if that's what you mean by lit up.

p.s.s. sorry about my previous post It was posted in haste and I apologize if it seemed rude.
My System SpecsSystem Spec
Reply

 getting lots of bsod's, several different error codes.




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
BSOD in a variety of tasks, lots of different error messages
Hi, I have been having steady stream of BSOD's served to me under a variety tasks. This has happened from when watching youtube clips, to being inactive, to using a word processor. I have updated my Video card drivers...etc, and I cannot seem to get to the source of the issue. I have...
BSOD Help and Support
BSOD error when computer goes to sleep. Unable to get error codes.
Recently I restored my computer to windows 7 after using Windows 8 for a short period of time provided by my university. I don't think the story as to why I went back is very necessary so I'll skip it and get onto my problem. Upon returning to Win7, I began to get some errors, namely my computer...
BSOD Help and Support
three BSOD's with different error codes
Hi all, Had three BSOD's the last week. The first two happend on the same day and seemed to be related to harddisk drivers. I have recently installed a Seagate Central NAS, and Seagate Dashboard, the software for that, was upgraded a few days before the first BSOD. I have not ran the...
BSOD Help and Support
BSOD - various error codes, various causes
BSOD's started on a clients computer over a week ago and have been happening daily. So far I've tried: uninstalling/reinstalling antivirus (MSE), turning off Windows Defender uninstalled old Norton av using cleanup tool updated drivers mobo/vid card/sound drivers checked RAM with memtest,...
BSOD Help and Support
BSOD different error codes
Hi, i have a fresh Windows 7 Ultimate x64 retail installation running on a new pc. The hardware is completely new. The system is running fine in safe mode but comes up with different BSOD every 15 minutes or so in normal mode. I think this has something to do with the grafics driver, the...
BSOD Help and Support
Lots of BSOD & Hungup - Lots of Event17 WHEA-Logger
Hello everyone I've been getting this error again and again, and my computer is hungup or BSOD after awail...:mad: Do you know what can I do to fix it? Or what the problem is?? Thank you!! Asrock X58 Supercomputer bios 3.10 i7 920 (bloomfield) @2.67ghz -1.128vol.
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 01:38.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App