BSOD During startup

Remove your CPU cooler, remove the thermal paste and clean the CPU and cooler with isopropyl alcohol, apply new thermal paste and install the Hyper 212 EVO CPU cooler.
Be sure the cooler is tight, if it's loose it will not cool properly.

Make sure the case wires are tucked out of the way so the system gets good airflow.
Always check the CPU core temps.

Your motherboards IMC is CPU/NB voltage.

Let me know what the CPU core temps are after you replace the thermal paste.
If the temps are good, you can run a stability test.

That's the way I do mine, just make sure it's a thin layer, too much can be as bad as too little, the trick is to get the right amount applied.

You should apply the paste, attach the cooler, then remove i the cooler and check if the paste is squeezed out on the sides this means you have too much.

This is a good review: Best Thermal Paste Application Methods

Sorry, should have post the info in the last post.

Check your BIOS for the (IMC) CPU/NB voltage and post it here.

You can test the CPU core temps with your most demanding game or run a stability test.

If you want to stress the system you can run OCCT.
OCCT stability checking tool
Run the CPU:OCCT test for at least 30 minutes, be sure to monitor your CPU and GPU temps, don't let the CPU go over 66°C.
Set the time before you start.
When its done, pass or fail, it will make some graphs. Post these here as they are useful for analyses.

For the OCCT graphs look in C drive > Users > (User name) > My Documents > OCCT
Post them here if you can find them.

The CPU temps are a little better, you may have too little or too much thermal paste.

Bump your CPU/NB offset to 1.300V.

Run memtest86+ for 7 full passes, with all RAM cards installed.
Best to run overnight as depending on the amount of RAM you have may take several hours.
If you get any errors you can stop the test.
RAM - Test with Memtest86+
If you get any errors with both RAM cards installed, remove one card and test again.
If you get any errors, swap the cards and test again.

Your last five crashes:

Code:

STOP 0x00000050: PAGE_FAULT_IN_NONPAGED_AREA 
Usual causes:  Defective hardware (particularly memory - but not just RAM), Faulty system service, Antivirus,  Device driver, NTFS corruption, BIOS
Probably caused by : hardware 
Could not read faulting driver name
IMAGE_NAME:  hardware
FAILURE_BUCKET_ID:  X64_IP_MISALIGNED
--------------------------------------------------------------------------------------------------------------------------------------------
Two of these.
STOP 0x00000109: CRITICAL_STRUCTURE_CORRUPTION
Usual causes:  Device driver, Breakpoint set with no debugger attached, Hardware (Memory in particular)
Probably caused by : memory_corruption
IMAGE_NAME:  memory_corruption
FAILURE_BUCKET_ID:  X64_MEMORY_CORRUPTION_ONE_BIT
--------------------------------------------------------------------------------------------------------------------------------------------
STOP 0x0000001A: MEMORY_MANAGEMENT
Usual causes:  Device driver, memory, kernel
PROCESS_NAME:  MsMpEng.exe
FAILURE_BUCKET_ID:  X64_0x1a_5002_nt!_??_::FNODOBFM::_string_+464b8
--------------------------------------------------------------------------------------------------------------------------------------------
STOP 0x0000003B: SYSTEM_SERVICE_EXCEPTION
Usual causes:  System service, Device driver, graphics driver, ?memory
Probably caused by : memory_corruption
PROCESS_NAME:  MpCmdRun.exe
IMAGE_NAME:  memory_corruption
FAILURE_BUCKET_ID:  X64_MEMORY_CORRUPTION_ONE_BIT

Good work with the CPU cooler and RAM, sometimes re-seating the RAM will give good results.

Enjoy your vacation, let us know the results of memtest86+ when you get back.