BSOD Help Please

Page 1 of 3 123 LastLast

  1. Posts : 15
    W7 Ultimate 64 Bit
       #1

    BSOD Help Please


    I have a new build...

    Shuttle SH67h3, i5, 8GB Gskill, old WD 160GB HD from last build, DVD

    and its has been crashing all over the place....




    Any Ideas? I think it has to do with BIOS or Video Drivers for a number of reasons but typical scenario is that when i go to run an embedded video (youtube) it crashes and the subsequently crashes until I turn it off for 5mins before turning on again.

    Please help, Thanks!
    Last edited by Milhouse0311; 05 Oct 2012 at 23:11.
      My Computer


  2. Posts : 15
    W7 Ultimate 64 Bit
    Thread Starter
       #2

    Some additional Info....

    I've run Memtest for over 24hrs at a time and just left the computer alone and its fine.

    The crashes only occur once I start web browsing, movies or games

    Everything has the same crash address ntoskrnl.exe+70040

    Most common drives that cause crashes are; ntoskrnl.exe, ntfs.sys and netio.sys

    Any thoughts?

    I'm thinking replace old HD and add new video card instead of using the onboard HD3000 graphics or send Barebones back to Shuttle and get new kit.

    Thanks Again,
      My Computer


  3. Posts : 15,026
    Windows 10 Home 64Bit
       #3
      My Computer


  4. Posts : 15
    W7 Ultimate 64 Bit
    Thread Starter
       #4

    Did i follow the instructions correctly this time?
      My Computer


  5. Posts : 15,026
    Windows 10 Home 64Bit
       #5

    Do you have any antivirus installed? I see none in your msinfo file.

    Run this tool and delete anything it finds:
    Anti-rootkit utility TDSSKiller

    Suggest you to use Microsoft Security Essentials.
    Microsoft Security Essentials - Free Antivirus for Windows

    Make a full scan with both (separately) once downloaded, installed and updated.

    STOP 0x00000050: PAGE_FAULT_IN_NONPAGED_AREA
    Usual causes: Defective hardware (particularly memory - but not just RAM),
    Faulty system service, Antivirus, Device driver, NTFS corruption, BIOS

    STOP 0x000000F7: DRIVER_OVERRAN_STACK_BUFFER
    Usual causes: Device driver, Malware

    STOP 0x0000000A: IRQL_NOT_LESS_OR_EQUAL
    Usual causes: Kernel mode driver, System Service, BIOS, Windows,
    Virus scanner, Backup tool, compatibility

    STOP 0x0000001E: KMODE_EXCEPTION_NOT_HANDLED
    Usual causes: Device driver, hardware, System service, compatibility,
    Remote control programs, memory, BIOS
    Run Disk Check on your hard disk for file system errors and bad sectors on it
    Disk Check

    PS: Any particular reason for not updating to Service Pack 1?
    Your windows is out of date.


    Report back
      My Computer


  6. Posts : 15
    W7 Ultimate 64 Bit
    Thread Starter
       #6

    Koolkat77

    I ran Kaspersky, nothing found
    CheckDisk no bad sectors, nothing reported

    I don't have service pack 1 or any antivirus because when i try to load those programs 9/10 times it BSOD's.

    When i tried to install MS Essentials, it crashed each time. I will try again...

    Currently I am running verifier.exe in the background as well

    Thanks for you help
      My Computer


  7. Posts : 15,026
    Windows 10 Home 64Bit
       #7

    okay, upload the dumps you get with verifier.
    Also,
    __________________

    1. Click on User CP on the top right of this page
    2. Click on Edit System Spec
    3. Fill in your computer specs
      System Info - See Your System Specs

    __________________
      My Computer


  8. Posts : 15
    W7 Ultimate 64 Bit
    Thread Starter
       #8

    Latest BSOD info attached since I started running verifier.exe

    I was able to get MS Essential Security installed and it ran fine with nothing found.

    Also updated my system info
      My Computer


  9. Posts : 15,026
    Windows 10 Home 64Bit
       #9

    There's a problem with the dump file. It tells me my symbols are wrong when I open your dumps but with others it's perfect.

    Are you following the instructions correctly? Please follow them again and upload the newest dumps only.
      My Computer


  10. Arc
    Posts : 35,373
    Microsoft Windows 10 Pro Insider Preview 64-bit
       #10

    Your crash dumps are not showing any finite probable cause. In such a situation, it is better to enable Driver Verifier to monitor the drivers.

    Driver Verifier - Enable and Disable

    Run Driver Verifier for 24 hours or the occurrence of the next crash, whichever is earlier.

    Let us know the results, with the subsequent crash dumps, if any.
      My Computer


 
Page 1 of 3 123 LastLast

Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 04:08.
Find Us