Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: BSOD after windows 7 Pro start up

19 Dec 2012   #1
wormington

Windows 7 Professional 32bit
 
 
BSOD after windows 7 Pro start up

Hi

I hope you can help me, every time I boot my pc it loads windows and then I get the BSOD.

The error message is STOP: 0x0000007F (0x00000008,0x8F503750,0x00000000,0x00000000).

I can start up into Safe Mode and have no problems. I have run the Memory Test for 8 passes with no problems.

I have attached the Dump files for your perusal, I would be extremely grateful if you can give me an idea of where the problem lies or of any other information that is required.


My System SpecsSystem Spec
.
19 Dec 2012   #2
x BlueRobot

 

Code:
BugCheck 1000007F, {8, 801e1000, 0, 0}*** WARNING: Unable to verify timestamp for mfehidk.sys
*** ERROR: Module load completed but symbols could not be loaded for mfehidk.sys
*** WARNING: Unable to verify timestamp for mfencbdc.sys
*** ERROR: Module load completed but symbols could not be loaded for mfencbdc.sys
*** WARNING: Unable to verify timestamp for MOBK.sys
*** ERROR: Module load completed but symbols could not be loaded for MOBK.sys
*** WARNING: Unable to verify timestamp for RapportPG.sys
*** ERROR: Module load completed but symbols could not be loaded for RapportPG.sys
*** WARNING: Unable to verify timestamp for RapportCerberus32_43926.sys
*** ERROR: Module load completed but symbols could not be loaded for RapportCerberus32_43926.sys
Probably caused by : mfehidk.sys ( mfehidk+27291 )
Code:
Usual causes:  Memory corruption, Hardware (memory in particular), Overclocking failure, Installing a faulty or mismatched hardware (especially memory) or a failure after installing it, 3rd party firewall, Device drivers, SCSI/network/BIOS updates needed, Improperly seated cards, Incompatible storage devices, Overclocking, Virus scanner, Backup tool, Bad motherboard, Missing Service Pack
Remove:

Code:
Start Menu\Programs\McAfee
Start Menu\Programs\McAfee Online Backup
This program is well-known to cause BSODs with Windows 7. mfehidk.sys and mfencbdc.sys are both drivers related to McAfee.

Use the McAfee Removal Tool:Install and perform full scans with: Remember to install the free version of Malwarebytes not the free trail; untick the free trial box during installation

Remove any other real-time protection programs or AV products, such as SuperAntiSpyware.

Run some hard-drive diagnostics and follow these steps: Find your hard-drive manufacturer and run their tests.

Additional Tests: Post a screenshot of Crystal Disk Info summary: Make sure you have the latest firmware for SSD, and ensure all the SATA and Power cables are connected to the drive.

Check for any file system errors and bad sectors using Option #2 of: Use this command with Disk Check:

Code:
chkdsk C: /f /r
Reseat all the cards within your system, and stop overclocking any components.

Update BIOS:

Code:
Phoenix Technologies, LTD 6.00 PG, 05/05/2009
Reduce the number of programs at startup, to avoid any driver or program conflicts:
My System SpecsSystem Spec
19 Dec 2012   #3
wormington

Windows 7 Professional 32bit
 
 

Thanks for that x Blue Robot, I'll get on it tomorrow morning and report back.
My System SpecsSystem Spec
.

20 Dec 2012   #4
wormington

Windows 7 Professional 32bit
 
 

Hi

I have worked through most of your list.
Removing Mcafee sorted out my BSOD, a scan with MalwareByte found 19 items all from PUP.MyWebSearch. I also installed Microsoft Security Essentials.

I will run the Hard Drive diagnostic tool at a later date, I have the disk ready.

Here is a screen shot from Crystal Disk Info
Attachment 246415
As you can see all is ok.

I have also checked the file system with no reported errors.

I have yet to identify my Ram to enable me to update the drivers for that.
I can only find one update for the BIOS and that is dated 11.17.2009 and only has a 'Fix PCI Video card display abnormality issue'.
I have reduced the number of programs loading at startup.

Thank you for your help and advice
My System SpecsSystem Spec
20 Dec 2012   #5
x BlueRobot

 

The BIOS update was more of a addition, if it was possible for your motherboard, and good to know your system is running stable
My System SpecsSystem Spec
Reply

 BSOD after windows 7 Pro start up




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
BSOD after Windows start-up
Hey guys, hope you can help me. Blue screen appears right after the desktop starts loading. Safe mode worked fine until just now - whenever I try to open a page in a browser - it crashes again. Attached debug info. BugCheck 1E, {ffffffffc0000005, fffffa80056323ef, 0, fffa003c} BCCode: 1E BCP1:...
BSOD Help and Support
BSOD trying to start Windows, gets to desktop then BSOD, then reboots
Hi guys, I encountered BSOD for the first time. Very annoying. Right now I have to run this on Safe Mode in order to access the internet. I also noticed I can't use Firefox right now, and instead am using iE. I couldn't run the the performance scan report either (time out?), but I did attach the...
BSOD Help and Support
BSOD before windows start
Hi, since 8 months i've been using windows 7 (64 bit) i've never had a blue screen... Now I cant even use windows normally, before Windows user login screen, y get the BSOD IRQL not less than or equal, and restart. In safe mode, the background are all black, no bars, only the mouse pointer, and...
BSOD Help and Support
BSOD 90% after every windows start!
Hello everyone, It has been around 2 weeks now since I installed Windows 7 and from the second I inserted the CD I had nothing but problems. The after loading the disc and starting the install screens, the computer would just stop along with the cd drive as if everything halted. Anyway after...
BSOD Help and Support
BSOD on windows 7 start up
Hey guys Having some problems with my computer blue screening on me when it goes to launch the OS (this problem happens before I make it to the log in screen). Usually it goes to a system repair and then asks me to do a system restore. I dont have to actually do a system restore and it normally...
BSOD Help and Support
Windows 7 BSOD after start up
I really have no idea why the hell this is happening. First It happened while I was playing Left4Dead 2 and I was like no sweat, and went to bed. Then It BSOD'd after I opened a program, then after restarting anything I do involving a program causes a BSOD, I run safe mode just fine but eveything...
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 01:11.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App