|04 Jun 2013||#1|
BCCode 116, Quadro 4000
This just reboots the system and no Blue screen or anything.
Problem Event Name: BlueScreen
OS Version: 6.1.7601.2.1.0.256.48
Locale ID: 1033
Additional information about the problem:
OS Version: 6_1_7601
Service Pack: 1_0
Files that help describe the problem:
Read our privacy statement online:
Windows 7 Privacy Statement - Microsoft Windows
If the online privacy statement is not available, please read our privacy statement offline:
|My System Specs|
|04 Jun 2013||#2|
Follow steps in the guide by Capt Jack Sparrow - Bug Check 0x116: VIDEO_TDR_ERROR Troubleshooting Tips | Captain Debugger
What you are experiencing is a TDR event (Timeout Detection & Recovery). There are many causes of these events, mostly hardware related. Please read my checklist below and see if you can diagnose your particular cause.
A couple of things jump out immediately. Your specs say you have 5GB of RAM, an odd number. That suggests that you added some RAM at some point. Mismatched or failing RAM modules can cause TDRs. You might want to test those sticks one at a time in Slot 1 before anything else. RAM problems can explain some of your other issues too.
Looking at some of your other posts I see you are running dual monitors also. This could be exposing a defect in your 9500GT that is triggering the TDRs. You should test with only one monitor attached to see if this is the case.
You are running lots of stuff on that box, so I would be as deliberate as possible in doing the diagnostic work.
"Display driver xxxxx stopped responding and was recovered"
Timeout Detection & Recovery (TDR) = "Display Driver Stopped Responding and was Recovered" is a useful feature that started in Vista and is also in W7 that allows the OS to try and recover from a video timeout so that the system does not crash to a bluescreen. Symptoms included a screen flash with the TDR message appearing one or more times or the screen blinking out to black. If the system cannot recover it will crash (Stop Error 116 typical). The issue is that the video card is not responding as expected. The solution is in the: why?
There is no one-size-fits-all solution to TDR errors. But the problem is usually found in the local environment (your computer). Finding the cause is a matter of checking every possible cause and uncovering the culprit through a simple process of elimination. By methodically running down a checklist of diagnostic procedures you should be able to find the cause and can correct it.
There are numerous reports of hardware solutions to TDR's. The most common are:
The order you do the diagnostics is not all that important. My personal strategy is to do the cheap & easy stuff first, the cheap & harder stuff next, and then the stuff that costs last. But whatever order you do it in you need to check or confirm the following:
Poorly written software and games will cause TDRs. But if this were the case it would affect lots of people, not just a few. Check the game's website & forums for patches and tips.
See if other people in the forums are having the same problem and if they were able to solve it and how.
You could also be asking too much of your video card. Check to see if your video card is tested and recommended for the game/program. Test the game at reduced settings.
WHAT ACTIONS CAUSE THE PROBLEM
It helps if you can isolate the actions that trigger the TDR. Most often it will be an application using 3D graphics. But if the incidents occur constantly it would point more towards defective hardware. If it happens more specifically (just when running Game X) it points towards overheating, settings, software, or driver issues.
GENERAL SYSTEM PERFORMANCE
You need to eliminate the possibility that your computer has a global problem. You can use a program like Prime95 to stress test your system. Free Software - GIMPS
You can run the "Stress Test" for a few hours or overnight. This will not tell you what the problem is, but it is helpful to uncover any issues your system has with instability and cooling.
Running a video intensive game for hours can generate some serious heat and overheating will cause video errors. You can check your temps by looking at your BIOS readings or use a free program like Speedfan SpeedFan - Access temperature sensor in your computer .
A real easy test is to just pull the side panel(s) off your case (You can also blow a house fan directly into the open case) and see if the problem goes away or gets better. If it does then the issue is definitely overheating. If you are overheating you need to look at installing some cooling upgrades. You want to look at ventilating the case (more or bigger fans), Upgrade your case to a larger gaming case (lots of fans, water-cooling), etc.
There are free utilities like BurninTest PassMark BurnInTest software - PC Reliability and Load Testing that you can use to test your system's cooling capability. Caution is recommended using these types of programs.
Bad drivers happen and they can get corrupted. Before installing or reinstalling any video drivers first completely uninstall all video software and the drivers. (Some people say to run a cleaner program from safe mode, some say this is unnecessary). Never rely on the driver package to overwrite the old drivers. Also: Delete the video driver folder (ex: C:\NVIDIA) in Windows Explorer (or windows may install the same drivers again!).
After uninstalling the old drivers and rebooting Windows 7 will install it's own WDDM 1.1 driver. Check for the video problem while using the generic Windows driver.
You can then install the latest drivers for your card (or try older drivers).
See This Tutorial: Installing and updating drivers in 7
Look in Device Manager and make sure there are no problem devices (yellow ! icon). Correct these by loading the correct drivers or disable the problem device and see if the video problem goes away.
Reseat video card and memory modules. Make sure the contacts are clean. Check all the electrical connections.
CHECK YOUR MOTHERBOARD VOLTAGES
In BIOS, check the listed voltages against the manufacturer recommended specs. Reset the voltages to factory defaults and see if the video problems disappear.
Memory errors can cause video problems. Run a program like Memtest86+ for at least 3 passes to see if there are any memory errors. Memtest86+ - Advanced Memory Diagnostic Tool .
You can also test for a bad memory module by installing one stick and testing, and then switch it out for the next stick, etc.
Overclocking can be a trial and error process. The clocks and/or multipliers you set or change for CPU, Memory, or GPU could be unstable. Eliminate this as a possibility by resetting these to their defaults to see if that clears the video problems. The simplest way to do this is to "Restore Bios Defaults", or Clear CMOS.
Some people have reported that by going into the video cards control panel and "down-clocking" the cards performance settings they were able to clear up the TDRs. Since W7 does not seem to tolerate any hiccups in the GPU, this would allow you to run a poor perforning card in the W7 enviroment.
So for instance, you could set the GPU clock from a 777 MHz factory setting to 750MHz, and the ram clock from a 1126MHz factory setting to 1050Mhz, or similar small change for your particular card.
Check for and install an updated BIOS, particularly if it says the newer BIOS corrects memory errors or bug fixes. You could also try loading the BIOS defaults.
While you are there, check the motherboard manufacturers forums to see if others are having issues with the same board.
WINDOWS POWER MANAGEMENT
Eliminate Power Management settings as a possible cause, especially if you are working with a laptop. These settings could be particularly important if the issue is in playing games.
Go to Control Panel > Hardware & Sound > Power Options. Under "Select a Power Plan" you will find that "Balanced" is the default setting.
At the bottom you will see a Down arrow next to "Show Additional Plans". Click that and select "High Performance". See if the TDR issue is affected.
Alternately, you can click "Change Plan Settings" next to the "Balanced" plan and change the setting to "Never" put the computer to sleep (This is the default on a desktop) and/or change when the display is turned off as a test.
You need to know that your power supply is delivering sufficient power. Power supply problems are the most common cause of video problems, especially using high end cards.
Check the power supply's amperage ratings. Be sure it has the ample amperage for your video card and the rest of the system.
Test the supply with multimeter to measure for a steady 12v to the card's power connectors. (The only true way to test a power supply would be to use the very expensive diagnostic equipment used in labs). But for us regular folks: I tested my power supply by hooking up my multimeter to the PCI-E connectors that I was using to power my video card (I used a spare pair from the power supply to run the card while I was testing). I then observed the meter while I used the computer, first watching the voltage, then the amps, to see if there was any drop-off or erratic behavior while booting or using the computer. My readings were rock solid. So I declared my power supply good.
Otherwise you need to replace the supply to eliminate this possibility. Or borrow one from another computer.
I suspect that a video card must perform flawlessly to operate in a Windows 7 environment and run the most recent games. If you tried all the above diagnostics and no problems were found then that leaves you with only one possibility: a defective video card. Some brands have the problem more consistently than others. You could check their forums for clues.
You could try your card in another computer running W7 to see if the problem goes along with the card.
You could try a different card in your computer. I bought an inexpensive card to use. My TDR's disappeared using a "lesser" card. Or borrow a card from another computer.
Otherwise RMA or replace the card.
TDR complaints have come from PC owners running virtually every PC configuration. They occur regardless of which video engine, manufacturer, driver, or system used. They are too numerous to write off as a random problem, but at the same time if people are getting their systems to run correctly using the same hardware and software that you are then it follows that your problem must be solvable.
More Info Here:
Timeout Detection and Recovery of GPUs through WDDM
NVIDIA Statement on TDR Errors - NVIDIA Forums
27116: ATIKMDAG has stopped responding error message
|My System Specs|
|Similar help and support threads|
Should i try to get a CPU with HD 4000?
My current setup has a Pentium G620 (HD Graphics 1000), which runs fairly well except for a few major drawbacks: When I want to watch Blu-Ray movies, PowerDVD's interface has some really annoying stuttering. skipping ahead or ff/rw also is somewhat unstable If I want to convert a movie, it...
|Hardware & Devices|
What to make of Quadro 600?
Hey guys, I;m looking for an entry level professional gpu and Quadro 600 seems to fit my budget.. Howver I cant seem to find any reviews about it from people who have actually used it.. Can somebody help me out here? I use CS5 (after effects heavily) and Autodesk Creation suite... Would be...
Nvidia Quadro NVS 400
Does anyone know if it is possible to get one of these suckers to work with Win7 x64? I bought the thing back when it was brand new and I spent like $600 on it and I don't want to have to give it up. Any advice would be much appreciated.
NVidia Quadro driver help
I have an nVidia Quadro in my desktop here at work, just installed Windows 7 Pro 32Bit (trying all the flavors before rolling out to prospective clients). I can get multiple displays running but I've encountered a problem that has driven me to the breaking point. From my onboard VGA, I can...
quadro nvs 285 on 64 bit 7?
everytime i install the forcewar drivers for my card or let 7 install its driver for my card i get the infamous blue screen saying it is the video driver causing the issue. i have my video driver as " standar vga adapter" right now and it works but obviously cannot set up both my monitors or play...
NVIDIA Intros Quadro CX
The new Quadro CX card has been designed to deliver 192 CUDA parallel processor cores, a total of 1.5GB of GDDR3 memory with 384-bit memory interface. The memory bandwidth is specified at 76.8GB/s and, as you might expect from such a monster of a card, it comes with some hefty power requirements...
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.
© Designer Media Ltd
All times are GMT -5. The time now is 12:36.