New
#51
now you have the link for the blend test https://skydrive.live.com/redir?resi...OtBoLluA-S5Esc
now you have the link for the blend test https://skydrive.live.com/redir?resi...OtBoLluA-S5Esc
Okay thanks for the results, could you please upload the temperature of your hardware when idle and under load?
for the temperature for my cpu in idle on occt cpu 36° core1 43° core2 39° core3 40° core4 39°
in burn with your prime 95 occt cpu 53° core1 68° core2 65° core3 65° core4 63°
i have de thermalright macho hr-02
Last edited by Bikette; 13 Jul 2013 at 03:20.
Okay, the temperatures look fine to me.
Run Memtest86+ for least 9-10 passes, and preferably overnight as it can take a while to fully complete.
Test each RAM stick individually, if an error is found then move the same RAM stick into the next DIMM slot and test again, if errors are found for the same RAM stick in every available slot then you have a faulty RAM module. On the other hand, if no errors are found in the next slot or the other slots for the same RAM module, then you have a faulty DIMM slot.
Test each RAM stick and every motherboard DIMM slot available.
hummm hard, because i have my hr-02 wo block the acces to the ram stick, if you are sure fo the ram, i change all. end if this is the mother board, i'm learning to fly my pc.
So, you've swapped the RAM?
I run memtest 86 , it works for 12 hours, he made five passes, zero error, but I have 12GB, I wait or not the 9 pass?
6/9 pass
i have try your technic,i have remove and set a number for every memory stick, i have set the module one on the slot one and the four on the slot two, the pc run but black screen, i have try with module 3 and 2 same issue the pc have ringing fastly after what none. i have un set a graphic card instal the driver of my (bloody)LG monitor now i wait the next bssod.( he have crash 4 before this message).
Last edited by Bikette; 14 Jul 2013 at 17:03.
Keep it running for up to 9-10 passes, and following the table as an example, will help identify if you have a bad RAM stick or DIMM slot.
Black screens are usually related to the graphics card or the driver.
Graphics Card:
WarningRead all the steps within the hardware test tutorials very carefully, as stress tests is designed run components to their maximum capacity, in order to point out failing or faulty hardware components
Use the following program to monitor your hardware temperatures during the stress test:
Please boot into the BIOS, and post the values for the 3.3V, 5V and 12V rails.
during memtest I found that only 5 memory module are analiser, but I have 6 modules of 2 GB.
my first question was memtest86 there a limitation of memory? <= 10GB
cm slot dead?
Now I'll re-run same test for 20 hours or 24 hours to see it will not.
edit: i have now my 6 stick of ram, i think to a bad connect
Last edited by Bikette; 15 Jul 2013 at 05:07.