BSOD error 0x0000000a

Crashed again.Here's the dump file

Code:

BugCheck 1A, {41287, 30, 0, 0}

Probably caused by : CI.dll ( CI!memcmp+93 )

Code:

Usual causes:  Device driver, memory, kernel

It seems that a illegal page fault has occurred, which leads to a more of a device driver related cause. There is also some Windows modules which are sharing the same memory address for some reason.

Code:

2: kd> .trap fffff880`03189e90
NOTE: The trap frame does not contain all registers.
Some register values may be zeroed or incorrect.
rax=0000000000000000 rbx=0000000000000000 rcx=0000000000000002
rdx=0000000000000001 rsi=0000000000000000 rdi=0000000000000000
rip=fffff8000ddba1c5 rsp=fffff8800318a020 rbp=fffff8800318a080
 r8=fffff8000dc60000  r9=0000000000000001 r10=0000058000000000
r11=0000000fffffffff r12=0000000000000000 r13=0000000000000000
r14=0000000000000000 r15=0000000000000000
iopl=0         nv up ei pl nz ac po nc
nt!MiResolvePageFileFault+0x1115:
fffff800`0ddba1c5 8b4830          mov     ecx,dword ptr [rax+30h] ds:00000000`00000030=????????

Scan for any missing, modified or corrupted protected Windows files with:

• SFC /SCANNOW Command - System File Checker

I'll do that.I also put my ram in to another ram slot and i haven't had a crash yet, it seems to have fixed my problem but i'm not sure.

Well i tried scanning but the command didn't work, i tried using the system update readiness tool like it says but that also didn't work, i can't do a system restore either

What error message does it give you, if any?

It says Windows Resource Protection Could Not Start the Repair Service, i did as it's suggested and set Windows Modules Installer to manuel, still the same.

Are you able to run the command at boot? You will need a Windows installation DVD or a System Repair disc.

SFC /SCANNOW : Run in Command Prompt at Boot

I tried it, got the same error.

Try reading through this TechNet thread - SFC problem - "Windows Resource Protection could not start the repair service"