BSOD Loop after installing HP printer drivers


  1. PixelMoney
    Posts : 3
    Windows 7 Ultimate x64
       New #1

    BSOD Loop after installing HP printer drivers


    So I recently had problems with installing windows, but i eventually was able to re-install it. I then decided to install all my drivers. I rebooted once so that the drivers would...do their thing. After i rebooted everything was fine and i went and installed my printer driver, i have a HP DeskJet 3 in 1 printer, i have forgotten the actual name of the product, but anyway i followed all the instructions on the install wizard, and it started to install, but it kept 'Not Responding', so i decided to just end it and do it another time, it started the uninstall process and said that i need to reboot my computer for it to take full effect. So i did. The windows logo loaded fine, but then i got the BSOD, for a brief moment, then my computer rebooted again. This loop went on for about 4 times. After that i held down the power button to turn my computer off, and turned it back on again. The same thing happened, but instead of doing the loop thing my computer suggested the startup repair. I ran the startup repair but it couldn't solve the problem. I don't know what i should do next.
      My Computer
    Quote Quote

  3. Arc
    Posts : 35,373
    Microsoft Windows 10 Pro Insider Preview 64-bit
       New #2

    Follow it:
    Troubleshooting Windows 7 Failure to Start

    Or, run Startup Repair for three separate times, with restarts after every single run.
    Startup Repair: Run three separate times.

    Then try to boot the computer up. If you cannot do it in the normal mode, try in safe mode, and post it following the Blue Screen of Death (BSOD) Posting Instructions.
      My Computer
    Quote Quote

 

  Related Discussions
BSOD multiple times in last week, usually after turning on laptop (sony vaio home prem 64 bit) and opening chrome. Just happened after installing new printer device drivers. please find log attached. Help appreciated. Steve
Hello, i am trying to install the drivers for an easycoder pf4i and am getting a message that states "already installed, try uninstalling and reinstalling later. I had already attempted to install but had a power failure during the installation and now cant install again. I went into print...
I currently have an AL-1540CS printer that's hooked up to the USB port of my PC. I went to the official SHARP Website to search for the drivers of it and I downloaded them. The problem is whenever I try to install the drivers it says: "The installer has detected an unsupported operating system....
This may well be a server issue. I just don't where to begin. I have a Windows Server 2003 file and print server on my home network. And I have an HP 4050 laser printer on the network that is shared through the W2k3 server. Previously, all PCs and laptops on my network had been running Windows...
Hello everyone. Newbie here with a perplexing problem I'm hoping someone here can help me with. Over the holidays I purchased a Gateway NV55C laptop computer running Windows 7 Home Premium, Pentium 4, 64 bit. My printer is a Kodak 3200 Series 3-in-one. No matter what I do I can not get the printer...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 07:09.
Find Us