Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Freshly installed PC BSOD Win7 pro 64bit

13 Aug 2014   #21
tmtz

Win 7 pro 64bit
 
 

Well it worked for about a day ran the bsod scanner right afterwards see if its still the same results


My System SpecsSystem Spec
.
14 Aug 2014   #22
carwiz

Windows 7 Pro-x64
 
 

The dump indicated a processor TLB failure. This has to do with converting virtual memory (addresses) to real address. The event log indicated a Kernel Processor Power fault. I'm thinking the power fault may be causing the TLB error if the processor enters a state other than G0 (C1, 2, etc.) during a passive cooling event.

While the log doesn't explicitly state the processor was throttling, it did indicate two idle states. The thermal report indicates the passive and active cooling levels are set at the same temperature and the critical temperature is only two degrees higher. There's one more thing I'd like you to try but you need access to the BIOS. Enter the BIOS and check the fan threshold/temperature settings. I'm not sure how they will be identified but the active threshold temperature should be lowered. In other words, the fan(s) need to come on at a lower temperature. It's currently set at about 73C and should be down around 40-50. I don't have the manual on the E6850 processor but the critical temperature could probably be raised too. The log indicated it was set at about 75C. Try a setting of 80.

Centaur78 may have been right all along.
My System SpecsSystem Spec
18 Aug 2014   #23
tmtz

Win 7 pro 64bit
 
 

I went into the BIOS to try to change the temperatures and I am unable to.
My System SpecsSystem Spec
.

19 Aug 2014   #24
carwiz

Windows 7 Pro-x64
 
 

Open an elevated command prompt (Run as administrator) and type verifier /query
Report the response. Close the console.

Perform a Clean Start (Boot) using this tutorial: Troubleshoot Application Conflicts by Performing a Clean Startup
Then report back if the BSOD continue with usual activities.
My System SpecsSystem Spec
19 Aug 2014   #25
tmtz

Win 7 pro 64bit
 
 

I will work on the clean start boot tomorrow,but it hasn't BSOD at all today. It did only once yesterday, its not happening as frequently as it had been. heres the output on the verifier /query
My System SpecsSystem Spec
19 Aug 2014   #26
carwiz

Windows 7 Pro-x64
 
 

Ok, not to scare you but that's what I was hoping for. It doesn't really mean what is says literally. I just wanted to know if Driver Verifier was turned on or off. Leave it off for the time being.
My System SpecsSystem Spec
03 Sep 2014   #27
tmtz

Win 7 pro 64bit
 
 

Looks like after 2 weeks of having a user use the pc its good. Ever since I updated the bios (with the exception of one time after) it has not bsod. Before the bios update the pc would bsod several times a day. I would like to thank everyone for giving me advice and on how to fix this problem.
My System SpecsSystem Spec
03 Sep 2014   #28
carwiz

Windows 7 Pro-x64
 
 

See post #16.
My System SpecsSystem Spec
03 Sep 2014   #29
tmtz

Win 7 pro 64bit
 
 

I apologize CARWIZ, thank you for noticing my bios needed to be updated.
My System SpecsSystem Spec
Reply

 Freshly installed PC BSOD Win7 pro 64bit




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
Freshly installed OS win7 64bit taking 30 seconds at Welcome screen
I just installed windows last night without any software on it but all the drives it takes about 30 seconds from putting in my password. I have nothing what so ever running in startup so I'm a bit confused. I'm using Crucial brand new SSD and 16gigs of G.Skill ram and both are working fine. Any...
General Discussion
BSOD on freshly installed Windows 7
Hello guys, I Installed Windows 7 Ultimate and I got a lot of BSODs so I decided to format and do a fresh install of Windows 7, this time enterprise but the BSODs continue System specs: Windows 7 Enterprise x64 Full Retail The hardware has 3 days. Windows was installed yesterday ...
BSOD Help and Support
BSOD tcip.sys , 0x0000000D1 Freshly installed win7 x64
Hello, i'm having 10 min intervall BDOS's after reinstalling my Windows 7 Ultimate, retailer bought My hardware is about a year old, the OS installation just under 1-2 hours old. Hopefully someone will have the time knowledge required to help me sort this out, meanwhile i'll try windows...
BSOD Help and Support
frequent bsod crushes on freshly installed PC
Hi, i'm having a lot of BSOD crushes on industrial PC that runs on Windows 7 32 bit professional edition.Sometimes it happens right on start up, sometimes after 15 minutes of work, sometimes after few hours . sometimes it appears when i open IE window, sometimes when i run DVR web based client. I...
BSOD Help and Support
BSOD freshly installed system
Hi guys, I?m desperate. I reinstalled windows 3 times because I couldn't figure out what is causing bsod...Here are the miunidumps...I don't know how to read them, Thank you so much
BSOD Help and Support
Freshly Build Win7 -64bit Computer Blue Screens or freezes randomly.
I recently build my first computer, using these parts (not sure what you need to know). Memory -*G.SKILL Ripjaws Series 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 1333 (PC3 10666) Desktop Memory Model F3-10666CL9D-8GBRL CPU - Phenom II X6 1090t black edition Thuban 3.2GHz* PSU - Corsair CMPSU-850TX...
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 04:26.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App