Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: BSOD on new pc build uncorrectable hardware error

05 Oct 2014   #1
ullise

Windows 7 Ultimate x64
 
 
BSOD on new pc build uncorrectable hardware error

Hello, i'm having problems with my new build on Windows 7.

Intel Core i5-4460 3.2GHz
Motherboard Gigabyte GA-B85-HD3
RAM Memory HyperX Fury Red 8GB DDR3 1600 MHz CL10
Graph card Sapphire AMD Radeon R7 265, 2048MB, GDDR5, 256bit
Power Supply Zalman ZM600-LX 600W
Hard disk Seagate Desktop SSHD 1TB 7200RPM 64MB SATA-III

I hope i didn't make any mistake in writing down this thread


My System SpecsSystem Spec
.
05 Oct 2014   #2
HonorGamer

Windows 8.1 Pro x64
 
 

Hello,

Code:
Start Menu\Programs\DAEMON Tools Ultra	Public:Start Menu\Programs\DAEMON Tools Ultra	Public
Please uninstall for now. DT is a know cause of BSODs with Win7.

Code:
BugCheck 124, {0, fffffa800a0d5028, be000000, 81136} 
BugCheck Info: WHEA_UNCORRECTABLE_ERROR (124)
Just like you said, BugCheck 124. Follow the steps below:

Quote:
BugCheck 0x124
You have a 0x124 hardware bugcheck. If the system is still under warranty, I would recommend sending it in to have diagnostic tests done and any bad hardware replaced.

warning   Warning
Before you proceed with the following, answer these two questions: Are you still under warranty? Does your warranty allow you to open up the machine to check hardware? If you are unsure of the answers to these questions, contact your system manufacturer. WARNING: The steps that follow can void your warranty!!!

For your hardware stop 0x124 crash, read through Stop 0x124 - what it means and what to try and use the following hardware checks to supplement that link.
  • If you are overclocking any hardware, please stop.

  • If you have an SSD, make sure the following are up to date:
    • SSD firmware
    • BIOS Version
    • Chipset Drivers
    • Hard disk controller drivers/SATA drivers
    • If you have a Marvell IDE ATA/ATAPI device, make sure the drivers are up to date from the Intel site or Marvell site and not from your motherboard/vendor support site.

  • Run all but the advanced tests with SeaTools for HDDs.
    SeaTools for Windows

    SeaTools for DOS
  • Monitor temperatures during the following tests.
    Use the following programs to monitor the temperatures.
  • Run the boot version of Memtest86+ paying close attention to Parts 2 and 3 of the tutorial. Also, in case Memtest86+ misses anything and comes up with no errors, run the extended version of the Windows Memory Diagnostics Tool for at least five passes. These you may want to run overnight since they take a long time to complete (run them an hour before bed each of the next two nights and check before going to sleep that they are still running).

    For Part 3: If You Have Errors: If you swap any memory components, follow these steps for ESD safety:
    1. Shut down and turn off your computer.
    2. Unplug all power supplies to the computer (AC Power then battery for laptops, AC power for desktops)
    3. Hold down the power button for 30 seconds to close the circuit and ensure all power drains from components.
    4. Make sure you are grounded by using proper grounding techniques, i.e. work on an anti-static workbench, anti-static desk, or an anti-static pad. Hold something metallic while touching it to the anti-static surface, or use an anti-static wristband to attach to the anti-static material while working. If you do not have an anti-static workbench, desk, or pad, you can use your computer tower/case by finding a metal hold in it, such as a drive bay.
    Once these steps have been followed, it is safe to remove and replace components within your computer.

Remember to read closely through Stop 0x124 - what it means and what to try for the crash.
Coutesy of: writhziden
Post back results
My System SpecsSystem Spec
05 Oct 2014   #3
ullise

Windows 7 Ultimate x64
 
 

it seems that now i can't even run any test...i open chrome and after aprox. 10-15 second i get the BSOD. I will try again later.
My System SpecsSystem Spec
.

05 Oct 2014   #4
HonorGamer

Windows 8.1 Pro x64
 
 

Can you try to put up the new files? Or run in safe mode with networking?
My System SpecsSystem Spec
05 Oct 2014   #5
ullise

Windows 7 Ultimate x64
 
 

The new files? you mean the new crash dumps files?
My System SpecsSystem Spec
05 Oct 2014   #6
HonorGamer

Windows 8.1 Pro x64
 
 

Yes.
My System SpecsSystem Spec
05 Oct 2014   #7
ullise

Windows 7 Ultimate x64
 
 

update: i managed to run seatools for win in safemode with networking. The first short DST started failed (it might be my fault). i will come back soon with the other results
My System SpecsSystem Spec
07 Oct 2014   #8
ullise

Windows 7 Ultimate x64
 
 

still not able to run the tests...i get the bsod after 1 min of running.

Later edit: i managed to run the prime95 hdd test, ran the first test (small fft) - 3 tests in 4 minutes with 0 errors and 0 warnings. I canceled the test when i saw that the cpu temp went up to 81 degrees.

LE2: i ran the second hdd test with prim95, but canceled it after 1 test because, again, the cpu temp went up to 82 degrees.
My System SpecsSystem Spec
07 Oct 2014   #9
ullise

Windows 7 Ultimate x64
 
 

double post
My System SpecsSystem Spec
07 Oct 2014   #10
HonorGamer

Windows 8.1 Pro x64
 
 

Can you fill out your system specs,

Double check your RAM, and MOBO make sure everything is compatible. If possible give me the information and I can do it. Not only can these be caused by bad hardware, but also incompatibilities.

Also, how many fans, try opening the side and putting a fan on it to make sure there is enough air getting to it.


Run a RAM - Test with Memtest86+ and launch it from a disk.
My System SpecsSystem Spec
Reply

 BSOD on new pc build uncorrectable hardware error




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
Error of uncorrectable hardware
My computer always BSOD when running the window , play LoL and do nothing (it is random occurrence) I only try to push in or out the display card and clean it, the BSOD will not to appear in stort time, but ,After a little time, the BSOD will appear again. I cannot to end resolved this error. ...
BSOD Help and Support
BSOD with Uncorrectable Hardware Error
I have recently recovered my computer hoping to fix the problem and it did not. Here is my file. Thanks for any help.
BSOD Help and Support
(BSOD) Encountered Uncorrectable Hardware Error Battlefield 3
Got an uncorrectable hardware error playing Battlefield 3. I have no idea what caused it all I know is temps were fine, all drivers are latest version and windows is up to date. I would appreciate if someone could look at my dump file and advise me on what went wrong. And also user profiles and...
BSOD Help and Support
BSOD uncorrectable hardware error
hi im new here and hopefully you can help me guys solve this irritating problem of mine. first here are the specs of my pc: cpu: amd phenom ii x6 1100t @ 4.134GHZ mb: asus crosshair v formula mem: 16gig corsair vengeance 1600mhz cl9 9-9-9-24 gpu: asus direct cu ii hd 6970 psu: hec cougar...
BSOD Help and Support
BSOD 0x00000124 uncorrectable hardware error
Hello, I have a PC about a year old that unfortunately has had a series of problems. It's had a faulty power supply and recently a faulty hard drive. Had both of these faulty hardwares replaced and then recently it began blue screening again whilst playing Dragon Age. This started occurring...
BSOD Help and Support
uncorrectable hardware error 124
I keep getting a bluescreen every so often, usually when playing a game. the codes on the most recent one read as follows BCCode: 124 BCP1: 0000000000000004 BCP2: FFFFFA8007ABC8D8 BCP3: 0000000000000000 BCP4: 0000000000000000
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 03:00.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App