Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Bsod driver_irql_not_less_or_equal

19 Oct 2014   #31
essenbe

Windows 7 Enterprise X64/Windows 10 Enterprise X64/Windows 10 Pro X64/Linux Mint
 
 

When you tried running without the graphics card did you completely remove the card from the computer?


My System SpecsSystem Spec
.
19 Oct 2014   #32
essenbe

Windows 7 Enterprise X64/Windows 10 Enterprise X64/Windows 10 Pro X64/Linux Mint
 
 

Also, as far as the size and manufacturer of the PSU, open the case and there should be the manufacturer's name and model # on the PSU and a large sticker on the side which will tell you the total wattage and the amps on the +12V. Some will have more than 1 +12V.
My System SpecsSystem Spec
19 Oct 2014   #33
boafx

windows 7 64 bit
 
 

Psu - allied model number al8500btx atx 500w switching power supply v.2.2./p4 atx 12v for pentium 4
My System SpecsSystem Spec
.

19 Oct 2014   #34
boafx

windows 7 64 bit
 
 

Quote   Quote: Originally Posted by essenbe View Post
When you tried running without the graphics card did you completely remove the card from the computer?
Yes took it out but the drivers where still installed would that matter?
My System SpecsSystem Spec
19 Oct 2014   #35
boafx

windows 7 64 bit
 
 

I found something in BIOS might be of interest under tools - asus EZ Flash 2 > AI NET 2 ,, it has "check Realtek LAN cable [disabled] , but I carnt enable it probably until I diasable something else
My System SpecsSystem Spec
19 Oct 2014   #36
essenbe

Windows 7 Enterprise X64/Windows 10 Enterprise X64/Windows 10 Pro X64/Linux Mint
 
 

Maybe, but probably not as long as the drivers were installed for the on board graphics. And Windows update would have installed them if there were none.
My System SpecsSystem Spec
19 Oct 2014   #37
boafx

windows 7 64 bit
 
 

also there is no CMOS profiles installed??? just clutching at straws here
My System SpecsSystem Spec
19 Oct 2014   #38
boafx

windows 7 64 bit
 
 

ARRR I just went to check updates and it wasn't on Auto and there are 172 available downloading now, I could swear I checked that- do you think this might be a cause
My System SpecsSystem Spec
19 Oct 2014   #39
essenbe

Windows 7 Enterprise X64/Windows 10 Enterprise X64/Windows 10 Pro X64/Linux Mint
 
 

You set the profiles, I am pretty sure. They are usually for you saving your bios settings for things like overclocking.

I am really curious to see the voltage readings on the PSU. The most respected PSU site I know, does not like it at all. It actually blew up while he was testing it. He says most 350W PSUs will put out more power. Read it for yourself. Allied AL-D500EXP 500W power supply review Review

That does not mean that is your problem, but could very well contribute to it. According to AnandTech a well respected site, your card can pull as much as 332W under full load. AnandTech | AMD?s Radeon HD 5830: A Filler Card at the Wrong Price

I am still not saying that is the cause of the problems you are having. But, it very well may be at least a contributor and if the reviews are correct, most likely will be at some point.

See if you can run this. it will take quite a few hours, but it needs to run for 8 full passes or until you get an error. If you get even 1 error, you can stop the test. You will know if it gets errors, as it will tell you and will show red lines at the bottom of the screen also. Just push escape to stop the test. If you have a USB thumb drive, I would download version 4.20 pre configured USB installer. Then you have to boot into the USB drive, not into Windows. The test will start on it's own and run until you stop it.
Please Run Memtest86+

information   Information
Please download from this site only http://www.memtest.org/ in the middle of the page are the Download links, you can download the ISO.zip or the Auto USB Flash Drive installer.zip

Extract the Zip file. If you chose the ISO image, burn it to a CD using Windows Disk Image Burner or any Image burner you may have. If you downloaded the Auto USB installer, extract it, insert your USB 2.0 Flash Drive and take note of the drive letter. Run the installer, select the Flash Drive Letter, check the format box and press next. It will install memtest86+ to a flash drive. You can use either V4.20 or V5.01. Boot from your selected media. If you use V5.01 it will tell you to press certain buttons at the start, please press no buttons. The test will begin on it's own and continue to run until you stop it. It needs to run for 8 complete passes or until you receive an error. If you receive an error, stop the test. Even 1 error is a fail. Each pass tests a different part of the ram and each of the 10 tests in each pass tests something different. It takes a minimum of 8 passes to completely test the ram, more passes are better. It is quite a long test and will take several hours depending on how much ram you have. Due to the time length it is best to run overnight. If you have any questions, please do not hesitate to ask
My System SpecsSystem Spec
19 Oct 2014   #40
essenbe

Windows 7 Enterprise X64/Windows 10 Enterprise X64/Windows 10 Pro X64/Linux Mint
 
 

Quote   Quote: Originally Posted by boafx View Post
ARRR I just went to check updates and it wasn't on Auto and there are 172 available downloading now, I could swear I checked that- do you think this might be a cause
Partially at least. But we still have the problem of corrupted system files. Once they are installed, see how it does. Once they are completely installed, click check for updates and install them, then keep doing that until it says there are no more. Especially the Important and recommended ones.
My System SpecsSystem Spec
Reply

 Bsod driver_irql_not_less_or_equal




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
BSOD driver_irql_not_less_or_equal
Hello! I've had it once before and it was McAffe's fault. It came back and I'm not sure what it is now. Besides this issue, my computer also randomly turns off by itself sometimes with no error messages, I think they're related. I updated my system specs and am posting the kernel dump (is that...
BSOD Help and Support
BSOD Driver_IRQL_not_less_or_equal
Hi Guys i need help on my BSOD attachment is the minidump you guys needed Thanks for the Help Regards Kang
BSOD Help and Support
Bsod, driver_irql_not_less_or_equal
Hello again WSF I got two BSOD's within a 2 hour interval (both dumps attached) Unfortunately I did not have DriverVerifier enabled on either of them, but I have enabled it now so if any further BSOD occur (wich I strongly expect) it will upload the dumps. Any help is much appreciated. ...
BSOD Help and Support
BSOD - driver_irql_not_less_or_equal
I am having frequent BSOD with irql message - please see the attached PERF- html and minidump info System specifics- Windows professional 64 bit 2 years old OEM installed from thinkpad. Appreciate any help. Thanks
BSOD Help and Support
Bsod: Driver_irql_not_less_or_equal
Problem signature: Problem Event Name: BlueScreen OS Version: 6.1.7601.2.1.0.768.3 Locale ID: 2057 Additional information about the problem: BCCode: d1 BCP1: 0000000000000028 BCP2: 0000000000000002 BCP3: 0000000000000000
BSOD Help and Support
BSOD - DRIVER_IRQL_NOT_LESS_OR_EQUAL, Help please.
Good evening to you all! :D Greetings aside; my computer has been crashing a lot recently, After a fresh install of Windows 7 Ultimate (x64 bit). I get a: DRIVER_IRQL_NOT_LESS_OR_EQUAL (BC Code d1) often and also IRQL_NOT_LESS_OR_EQUAL (BC Code a) every now and again I generally get the...
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 03:38.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App