Code:
BugCheck 7A, {fffff6fc4000a958, ffffffffc000000e, 180848860, fffff8800152b758}
GetPointerFromAddress: unable to read from fffff80002ef8278
*** WARNING: Unable to verify timestamp for win32k.sys
*** ERROR: Module load completed but symbols could not be loaded for win32k.sys
Probably caused by : memory_corruption
Followup: memory_corruption
Code:
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
KERNEL_DATA_INPAGE_ERROR (7a)
The requested page of kernel data could not be read in. Typically caused by
a bad block in the paging file or disk controller error. Also see
KERNEL_STACK_INPAGE_ERROR.
If the error status is 0xC000000E, 0xC000009C, 0xC000009D or 0xC0000185,
it means the disk subsystem has experienced a failure.
If the error status is 0xC000009A, then it means the request failed because
a filesystem failed to make forward progress.
Arguments:
Arg1: fffff6fc4000a958, lock type that was held (value 1,2,3, or PTE address)
Arg2: ffffffffc000000e, error status (normally i/o status code)
Arg3: 0000000180848860, current process (virtual address for lock type 3, or PTE)
Arg4: fffff8800152b758, virtual address that could not be in-paged (or PTE contents if arg1 is a PTE address)
ERROR_CODE: (NTSTATUS) 0xc000000e - A device which does not exist was specified.
DISK_HARDWARE_ERROR: There was error with disk hardware
Looks like your hard drive could be failing. Lets start there first.
Try downloading Crystal disk info to check the Smart stats and see if there are any errors
Download Center - Crystal Dew World
Report back with the results.