Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Boot issue, 0xc0000098 ci.DLL file issue

20 Dec 2014   #1
Killerhipo

Windows 7 Home Premium x64
 
 
Boot issue, 0xc0000098 ci.DLL file issue

OK so I hope this can be a quick fix and thanks for your help.

* Randomly computer didn't start, get something telling me that the ci.dll file is missing or corrupt and error 0xc0000098

* safe mode and last know good configuration both result in bsod

* Tried a few things, disconnect all other drives (2 raid HDD, and one normal HDD that I used to have windows on before switching to current SSD)

* Tried putting the installation disk in but it does not recognize the drive under any circumstance, can't find the drivers under "load driver"

* Tried a few other things on this site like bootrec.exe and and checkdsk or something, either I didn't do them right or they didn't work

* Now I get an message "Reboot or select proper boot device or insert boot media in selected boot device and press a key_"

I'm not a computer noob but this is beyond me. I hope someone can give me a hand, I appreciate all the help I can get!

Oh and sorry if this isn't the right category it looked like the best option.


My System SpecsSystem Spec
.
21 Dec 2014   #2
Laith

Windows 10 Professional x64
 
 

Have you tried put your windows drive on another computer?

Try these steps:
SFC /SCANNOW : Run in Command Prompt at Boot

Startup Repair Infinite Loop Recovery
My System SpecsSystem Spec
21 Dec 2014   #3
essenbe

Windows 7 Enterprise X64/Windows 10 Enterprise X64/Windows 10 Pro X64/Linux Mint
 
 

Go to bios and see if your hard drive is 'seen' in BIOS.

In BIOS check your sata controller to see what it is set to (IDE, AHCI or Raid) I assume if you are running raid it should be set to raid.

If you know your BIOS settings, set optimized defaults, then set your Sata controller to what it is supposed to be, Make sure your ram timings, frequency and voltage are set to manufacturer's specs, set the boot order, save and exit.

Work through these steps, Troubleshooting Windows 7 Failure to Boot
My System SpecsSystem Spec
.

Reply

 Boot issue, 0xc0000098 ci.DLL file issue




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
Uninstalled Linux OS dual boot with Windows 7 now boot issue.
Tried Ubuntu & didn't like it so wanted to remove it completely. After deleting & recovering that portion of (G: ) which is where Ubuntu was installed, I couldn't boot in Windows 7. I was able to use my install disk to load into repair. The OS it found was- OS -Windows 7 Partition Size -...
General Discussion
Reboot and Select Boot device or Insert Boot Media - Issue
Here is my system: Whitebox PC, 4 years old Motherboard: ASUS M4A78 PLUS, Bios: v2101 Proc: AMD Phenom 9550 Quad-Core Disk Drive: Patriot Pyro 120 GB (just purchased) Window 7 Ultimate 64-bit 2 3x SATA Drives for Data I wanted to breath in some new life into this older PC, purchased the...
General Discussion
Windows 7 boot issue with master boot record
Hello, My Old hard drive has Windows Vista Ultimate 64 bit installed on it. I purchased the Windows 7 Home Premium upgrade and ran the upgrade. Removed the Vista hard drive, and can not start Windows 7. Only issue on this system, I have upgraded two other systems without any problem. SSD...
Installation & Setup
Boot\ BCD error 0xc0000098 cannot find windows installation
Hi, I got a virus on my laptop lastnight. Everytime I boot, try safemode, or the recovery partition I recieve BCD error 0xc0000098. I attempted to run /rebuildbcd from the command prompt of the repair disc, it scanned for windows installation and was unable to find any. If I select load drivers I...
Hardware & Devices
Boot issue after removing original OS in dual boot
Hi, I seem to have royally trashed my boot capability. Please help. The original set-up was as follows: Vista Home Premium was installed on a two-partition disk Subsequently, Windows 7 was installed on a single-partition disk; I could not upgrade because it was Professional edition, and I did...
Installation & Setup


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 16:05.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App