Look at your sata controller in bios, or go to device manager and look under IDE ATA/ATAPI Controllers, you should see at the bottom a name with AHCI in it or IDE in it. That will tell you which it is set to. Don't change it or your computer won't boot. there is a way, I'll tell you how if you need to change it
I see a amd sata controller (ide mode) in the device manager
ok so was just viewing device manager and typing on forum with my phone computer crashed here is new ble screen i think old is there two
Also not sure entirely how to enable ahci in bios is that in my manual
It was set to ide i now changed it to ahci that should be better right?
Code:Use !analyze -v to get detailed debugging information. BugCheck 109, {a3a039d898495523, b3b7465eeac62479, fffff800034b07a8, 1} *** WARNING: Unable to verify timestamp for win32k.sys *** ERROR: Module load completed but symbols could not be loaded for win32k.sys Probably caused by : memory_corruption Followup: memory_corruption
Any ideals as to why its saying memory corruption i have already been down the whole testing memory road or could it be to do with the memory not being in the blue slots like profdlp suggested
Quote