New
#11
TRIM not supported?
i think PSU is good, yet i bought ChiefTech which isnt so bad... I used it for 3-4 years alrdy, and AIDA shows voltage is pretty high
Mm the volts look out mate better run HW Info again and do not shut the initial right hand panel down an check the CPU volts etc in that screen. - see pic
Now the shot of the volts in the pic you sent are out of whack by some considerable margin what I don't get is it doesn't mention the section name there ie mine has Nuvoton so yours should have something like that.
Ah I think I see the readout of the volts was not HW Info as per part A: of my instructional? if not please run the HW Info and post back a shot of the results. I need to see what the volts come up in that program please.
Good point by Layback Bear too mate and just as a matter of interest how old is this machine? and you use it for work I take it or for your own business?
BIOS:
1.05 = 1.056 V
3.3 = 3.312 V
5.0 = 5.060 V
12 = 11.857 V
Changes isnt much like 0.012 + -
I personally would replace a power supply that didn't have at least 12V in the bios.
Considering the bios voltages are at idle.