DISKPART : At PC Startup / Tutorial


  1. Bare Foot Kid
    Posts : 22,814
    W 7 64-bit Ultimate
       New #1

    DISKPART : At PC Startup / Tutorial


    This is just a simple little guide that I wish I would have had yesterday; I hope it'll be useful.

    DISKPART : At PC Startup
      My Computer
    Quote Quote

  3. Bare Foot Kid
    Posts : 22,814
    W 7 64-bit Ultimate
    Thread Starter
       New #2

    Bare Foot Kid said:
    This is just a simple little guide that I wish I would have had yesterday; I hope it'll be useful.

    DISKPART : At PC Startup


    Just wanted to bump this up in-case some have not seen it.
      My Computer
    Quote Quote

 

  Related Discussions
PC is booting to startup animation but not moving past. Started up windows repair and recovered to earlier point. No dice. Loaded up CMD in the start-up repair and ran a bootrec.exe /fixboot. Error. Bootrec.exe /scanos, None found. Which is weird because it boots into the start-up animation so that...
Open Windows DISKPART at System Startup This is an outline of the methods to boot (start) the PC to open DISKPART so you can manipulate the Solid State Drive (SSD) or Hard Disk Drive (HDD) partitions before you start an installation or for any other reason. Let's get started! Windows 7 Full...
Diskpart
in General Discussion

I am trying to do a diskpart/clean all via command prompt. Should the command prompt opened via repair menu at startup be at c:\windows\system32 or x:\sources or doesn't matter? Here is the tutorial that I am doing this according to: ...
DiskPart help
in Installation & Setup

Ok i couldn't mark my D partition as active because there wasn't a "Mark as Active" in diskmgmt.msc. so i tried to do it in command Prompt like it is described here.https://www.sevenforums.com/tutorials/71432-partition-mark-active.html?ltr=P But the problem is that there is 3 partitions listed...
Using Diskpart
in General Discussion

Hello everyone. What I would like is to do is a "secure erase" (write zeroes) to a partition of a HDD before a clean install of Windows 7. If I were to boot to a https://www.sevenforums.com/tutorials/682-command-prompt-startup.html?ltr=C would the series of commands in the snip below...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 19:52.
Find Us