Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Removing A Sticker

01 Sep 2011   #51
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

I'm still trying to locate the power door lock relays without any success so far. There is no space behind the driver's side kick panel, and I removed the plastic guard to access behind the dash on the driver's side, and found nothing. I have been searching for a free repair manual, either online or download, but what little I have found doesn't go into sufficient detail to be of any help in this particular instance. I even called the county library, and all they have is Chilton's, which I know is too basic to be of use.

Therefore, I'm considering buying a membership in an online repair manual service, but I'm wondering if anyone can advise me as to who would have the best service available?
My System SpecsSystem Spec
01 Sep 2011   #52
Zepher

Windows 7 Ultimate 64bit
 
 

I may go to my brothers shop tomorrow and if I do I'll get the location of the relay and diagrams for the circuit.
I'd ask him to do it but they are really busy there.
My System SpecsSystem Spec
01 Sep 2011   #53
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

Thanks, that would help a lot.
My System SpecsSystem Spec
.

01 Sep 2011   #54
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

Just thought that I should remind you that there is 2 module locations needed...the power door lock relays and the body control module (BCM).
My System SpecsSystem Spec
01 Sep 2011   #55
A Guy

Microsoft Community Contributor Award Recipient

Windows 7 Home Premium x64 SP1
 
 

In googling, I see reference to relay panel being in the engine compartment. A Guy
My System SpecsSystem Spec
01 Sep 2011   #56
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

Yes, but which relay? I looked over the engine compartment, and the only relays that I found were in the fuse box, but weren't related to what I'm looking for. I may have located the body control module. One thread I found on a forum said that it was under the center console, but even if that is true, it still leaves the power door lock relay module location to be found.
My System SpecsSystem Spec
01 Sep 2011   #57
A Guy

Microsoft Community Contributor Award Recipient

Windows 7 Home Premium x64 SP1
 
 

I'm just throwing tidbits I know. Hopefully Zepher will come through for you. There are many mentions of door locks issues in general that state that the relay is in the door panel along with the actuator. A Guy
My System SpecsSystem Spec
01 Sep 2011   #58
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

Hmm, I tend to doubt that, because from what I have read, there is only one module with 3 relays inside, which controls all 5 doors, and if that is so, it wouldn't make sense for it to but put inside of just one door. Then again, relays are such common components, that it wouldn't surprise me if there were some kind of relay there.
My System SpecsSystem Spec
03 Sep 2011   #59
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

i found some repair manuals on eBay for my vehicle for ~$13 - $25, which I'm awaiting responses from the vendors about them, but I'm wondering if anyone has used something like this. The ad claims that it is like one used by professionals, rather than being like Haynes, Chilton, etc. Are they?

http://cgi.ebay.com/ebaymotors/Chevr...item4aad9a4599
My System SpecsSystem Spec
06 Sep 2011   #60
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

The wheel that I ordered for my spare just arrived, and after getting it out of the box...which was no small task, I noticed that it looked wider than I expected. I measured the distance between the beads at 7". Now I'm wondering if it will fit a P235/75/R15 tire properly?

EDIT: Yes, I found a tire calculator and it falls right in the middle, so I guess it is good to go, except that I want to clean it up some first.


Attached Images
Removing A Sticker-tire-calculator.png 
My System SpecsSystem Spec
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar help and support threads
Thread Forum
W7 key on laptop sticker is suspect
I thought the clean install of Windows 7 (x64) on my son's Acer Aspire laptop had gone OK but I reckoned without Microsoft's activation. I ran the install using a retail disc which came with another computer. Before running the install I took the precaution of running Belarc Advisor on the...
Windows Updates & Activation
Windows 7 Sticker?
I want to get a replacement sticker for my R580 Laptop. It's just a sticker that says windows 7 but it got all scratched up and it looks so horrible. were can i download one i can just print off for free?
Chillout Room
Question Regarding Product Key (sticker)
Hi again! I have a question regarding the product key 'sticker' located underneath laptops and/or the side of your desktop. Before i begin, let me just say that the question(s) below are basically just out of curiosity (for now). It sure will come in handy in future if i need to perform such...
General Discussion
Windows 7 sticker
Hi, I need windows 7 system sticker (original size, I think it's 21mm x 21mm / 600dpi).. Format of image can be psd, jpg, gif, or any other. .If someone can scan and so on.. I found many stickers but I am not satisfied with the size of image (too small images). This is what I found : ...
Chillout Room
Adjusting RAM voltage to sticker on RAM
I have some new G-skill 1066 Mhz RAM. My motherboard has the voltage at 1.8V. The RAM spec voltage is 2.0-2.1V. I have set this at 1.9V but am wondering if going to 2.0 or 2.1V would be a good idea. I have seem some tutorials and 2 page long papers on overclocking RAM but this is more simple. Is it...
Hardware & Devices


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd

All times are GMT -5. The time now is 19:46.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App