Windows 7 Forums

Conversation Between Everlong and Rockit
Showing Visitor Messages 1 to 3 of 3
  1. Rockit
    19 Nov 2012
    Sorry about the late reply. I enabled "Raid" in my bios and changed the value in the registry. I was able to run a SSD program and it now detects the Trim feature and runs it thru the process. Is this something I should do more than once?
    Thank You Very Much For Your Assistance.
  2. Everlong
    05 Oct 2012
    Hey, I don't think AHCI is supported on your motherboard. It was a while since I helped write that tutorial, but if I remember it was only the nForce boards with onboard graphics that supported AHCI.

    It shouldn't be too much of a worry though. The nForce chipset can still do NCQ to the chipset, and you can still get the TRIM command enabled with the IDE controller. My guide was just how to setup the Microsoft IDE controller, not how to enable AHCI on the nForce 4 chipset. If you've followed the steps on that tutorial then you should be good to go
  3. Rockit
    04 Oct 2012
    I have just been able to buy a SSD. I see on the forum that you have the magic to enable ACHI on Nforce Motherboards. I must not be doing something right because I am not having any luck. I have a DFI Lanparty Nforce 4 Ultra d an a plextor M3 Pro 128 Gig. If you have the time will you assist me in getting this done if it is possible.
    Thank You
Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 00:24.

Twitter Facebook Google+

Windows 7 Forums

Seven Forums Android App Seven Forums IOS App