Windows 7 - Windows 7 problem Minecraft freeze

After loading minecraft and playing for a few minuets trying to close it minecraft freezes up the entire computer even task manager and then we must shut the computer off by the main power and after a few minuets of freezing it comes back to normal what is the problem?

Please provide us with your Event Viewer administrative logs by following these steps:

1. Click Start Menu
2. Type eventvwr into Search programs and files (do not hit enter)
3. Right click eventvwr.exe and click Run as administrator
4. Expand Custom Views
5. Click Administrative Events
6. Right click Administrative Events
7. Save all Events in Custom View As...
8. Save them in a folder where you will remember which folder and save as Errors.evtx
9. Go to where you saved Errors.evtx
10. Right click Errors.evtx -> send to -> compressed (zipped) folder
11. Upload the .zip file here.

Please follow the Blue Screen of Death (BSOD) Posting Instructions to provide us with the crash report for this crash. This will allow us to give informed troubleshooting steps for the problems you are experiencing.

I have asked that your threads be merged by one of our administrators.

After starting up our computer we get mulitple freezes and after about 10 mins of this there is a total freeze and this message pops up:
the instruction at 0x0000000007628eddf refereed memory at 0x0000000076250e20 The required data was not placed into memory be occuer of I/O from of 0x000000e.


What does this mean and how can we fix this




ok here is the file

You are receiving the following message:
Run Disk Check with both boxes checked for HDDs and with Automatically fix file system errors checked for SSDs.

ok so after following the disk check steps i restarted it so i could check the desk thing and this showed up

Should I continue or restart?

Try the following steps to see if you can get the disk check to run. Your hard disk has a lot of problems at the moment and really needs to run the check to recover bad sectors.

1. Go into your BIOS and load default settings to clear the CMOS memory.
2. Save Settings and exit the BIOS.
3. Shut down and turn off the computer.
4. Unplug the computer from the wall or surge protector (then remove the battery if it is a laptop).
5. Hold down the power button for 30 seconds. This closes the circuit and ensures all power from components is drained to clear the software connections between the BIOS and hardware and clear any corruption in the temporary memory.
6. (If it is a laptop, plug the battery back into the laptop and then) Plug the computer back into the wall.
7. Turn it on to reinitialize the software connections between the BIOS and hardware, and post back your results.

Also, do you have a Windows 7 installation DVD or repair disc?

K um where is the bio cause when I press a key to continue it just says the same thing over again

K well I did a system diagnostic and it says error code bioHD-2 no drives detected

Out computer doesn't accept repair disks should I try a system recovery

You can get into the BIOS by turning the computer off, and then when it turns on, immediately start tapping F2, F10, DEL. Try one key, turn off the computer, then try a different key.

What is your motherboard or vendor (DELL, HP, GATEWAY, etc)?

Uh well our computer is a HP pavilion our mother board may be a PEGATRON im not sure

For HP, F10 should start the BIOS. Tap F10 immediately after turning on the computer. You may have to tap it multiple times before the BIOS shows up. Then go to the exit section and select Load Setup Defaults. Save and Exit. Then do the other steps I outlined. Hopefully that will allow the computer to see the drive.