Windows 7 - Problems with Windows 7 booting

Hello

Firstly,I don't know if this messages is right alocated... I hope so. But seing the forums, I didn't know where to put this...

I'm having problems with the Windows 7 booting. I had installed Windows 7 and I wanted to install Ubuntu Netbook Remix in other partition. My surprise was when I was not get inside of Windows 7. Looking for internet I could add the windows 7 entry on the Grub.

When I choose Windows 7 in that Grub it doesn't get inside... it shows a "-" in the left-up corner and nothing more happens.

Then... I use the Windows 7 cd...well.....USB version this time (I'm in a netbook). When it charges...I click on repair system. and it is capable to recognize that there is Windows 7 partition. Then I have done a lot of things:

- Click on fix startup
- Click on promtp and do:
- bootsect /nt60 c:
- bootsect /nt60 c: /mbr
- bootrec /FixMBR --> here I had a problem, because it put a MBR that fails and then I couldn't enter on Ubuntu (I had to repair the grub).
- bootrec /FixBoot
- bootrec /RebuildBcd -> That said I don't have any windows partition. That is false, because it's capable to recognize it in before steps.

All of that I have tried didn't worked to me...any suggestion?

thank you so much!

Welcome!

I'm no expert in GRUB, so unfortunately, I can't give you instructions for dual booting with Linux.

However, I can tell you how to repair the Windows 7 installation.

First, mark your Windows partition as active: http://www.sevenforums.com/tutorials...on-active.html

Then, run bootrec /fixmbr, bootrec /fix boot, and bootrec /rebuildbcd.

That should do the trick.

Good luck!

~JK

Hello LeGeNDuS, and welcome to Windows Seven Forums.

When dual booting with Ubuntu, you have the chioce of using Grub as your boot menu, or using the Windows 7 bootmgr as your boot menu. It would seem you have been repairing back and forth but not ever getting both Windows and Ubuntu on the same boot menu?

Grub is usually very Windows friendly and will automatically add a Windows menu entry. Since the introduction of Grub2, we must know which version of Grub you are going to use because the instructions are not the same. The link at the bottom of this post shows how to repair Grub2 and add a Windows menu entry.

You can also use the free utility EasyBCD2 to add a Linux menu entry to your Windows 7 bootmgr menu.

Attaching a screen shot of your hard drive map from Drive Management to a post would also help.

Screenshot and Upload using MWSnap

Screenshot with Paint

http://www.sevenforums.com/tutorials...en-forums.html

Hope this helps!
Robert

Thank-you for the answer. Jonhatan king i have done it. But it says that bootmgr is missing when i rebooted. What can i do?. Thanks

If you're sure the Windows partition is marked as active, try a startup repair. You may need to run it a few times.

Startup Repair

thank you so much!!, I'm on my Windows 7... now I would try to add the linux entry on the windows startup like said iseeuu with easy bcd....

I'll say the results here.... thanks again!

Finally I needed to reinstall ubuntu...but now they are working rightly, thank you!

Great, thanks for reporting.

Anything else we can help you with?

For the moment, that's all, thank you so much, very usefull your information.