How to get back BIOS booting screen?


  1. Posts : 4
    windows 7 32 Ultimate
       #1

    How to get back BIOS booting screen?


    Repair company ****ed up my PC, they changed booting sequence and switch off BIOS booting screen. Now when I want to reinstall my system (because of serious virus) my PC doesn't accept booting win DVD and I can't see any port messages. Can't acces BIOS. I tried taping 'delete' , 'F2' , 'TAB' , 'F8' non of it works. Maybe it works because when I tried taping them I couldn't see anything on screen 'no signal to monitor' and system didn't start at all. It takes 15 minutes to start system now without touching anything.

    It's new computer connected to plasma screen via HDMI. Whole spec is ni my profile.

    Can somebody help me pls with that???
      My Computer


  2. Posts : 1,009
    Windows 7 Ultimate 64 bit SP1
       #2

    Check your motherboard manual, they might say something about that hiding bios thing :)
    The bigger monitor resolution shouldnt be a problem in any ways, but no signal is strange, if you have onboard as well (maybe not) then try to plug the TV into that port, rather than the video card.
    also try pressin escape while booting, but don't hold it down, delete should have been worked previously

    Maybe ASUS has an on-the-fly utility on the mobo install disk, to tweak to bios, try reset bios through that thing.
    Last edited by Brink; 27 Jun 2011 at 12:00. Reason: merged
      My Computer


  3. Posts : 4,466
    Windows 10 Education 64 bit
       #3

    There should be a clear CMOS/Bios reset jumper on the motherboard. That jumper will reset the BIOS to failsafe defaults. Instructions on how to use it and where it is should be in your motherboard manual. Read them before you attempt it or you could damage your motherboard. Taking the CMOS battery out for a couple of minutes should do the same thing. My guess is Fast Boot was likely enabled. Once you reset it you'll have to set the time and date, boot order, etc, etc.
      My Computer


  4. Posts : 1,326
    Windows 7 Ultimate RTM (Technet)
       #4

    winpomocnik said:
    Repair company ****ed up my PC, they changed booting sequence and switch off BIOS booting screen. Now when I want to reinstall my system (because of serious virus) my PC doesn't accept booting win DVD and I can't see any port messages. Can't acces BIOS. I tried taping 'delete' , 'F2' , 'TAB' , 'F8' non of it works. Maybe it works because when I tried taping them I couldn't see anything on screen 'no signal to monitor' and system didn't start at all. It takes 15 minutes to start system now without touching anything.

    It's new computer connected to plasma screen via HDMI. Whole spec is ni my profile.

    Can somebody help me pls with that???
    Look for QuickBoot in your bios or something similarly named...turn it off.
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 20:36.
Find Us