New
#11
You have to install the driver at the windows setup when it asks for it. When you see the drives at the setup asking where you want to put windows.
If you can't see it in there something is a miss.
You have to install the driver at the windows setup when it asks for it. When you see the drives at the setup asking where you want to put windows.
If you can't see it in there something is a miss.
Go to the mother board home page & look in the download section. You should find it in there.
ASUSTeK Computer Inc. -Support- Drivers and Download P6T Deluxe V2
under sata
DescriptionIntel(R) Matrix Storage Manager Driver V8.9.0.1023 for Windows 32/64bit XP & Windows 32/64bit Vista & 32/64bit Windows 7.(WHQL)
Intel(R) AHCI/RAID Driver Disk for Windows 32/64bit XP & Windows 32/64bit Vista & 32/64bit Windows 7.File Size23,61 (MBytes)2009.09.01 update
scrooge
That didn't do it. I contacted crucial and they told me to update the firmware. I however made a huge mistake, i didn't check my Firmware version assuming it was 001. It was actually 006, and i "updated" it to 002. Now, when i boot my computer, the Bios screen after the Marvell loading one, kind of freezes, unabling me to enter the bios. I changed from 6 GB sata to 3 GB sata, and now it freezes for one minute, and loads normally. However, the SSD won't be detected by the controller. The bios will though.
So whenever i am on the bios, i can choose two of those drives. But, when i try to update it to 006 it says no drives could be found. Also, when the marvell controller is loading, it also says no hard drives could be found.
What do i do? I have tried setting it to IDE Compatible, AHCI and Raid, but no good results. Any kind of feedback will be appreciated.
Thanks,
Alex.
mate use www overclockers com for your tech questions. you cant boot from raid on maximus iv from red marvell sata the two red ones closest to the grey ones are intel sata and then you can ctrl i