How do I fix the reboot and select proper boot device.


  1. Posts : 1
    Windows 7 Home Premium 64 bit
       #1

    How do I fix the reboot and select proper boot device.


    OwHi everybody i dont know is i should to post this issues here but i need help w/ booting my system build i connected my optical drive and my hdd and when power up everything look OK until goes to the monitor I see this black screen with that message I trying several things but not success how I get off of that screen so I can go to the BIOS interface and work from there I was able to see the BIOs before I installed this two drivers l don't understand can somebody help me with this I afraid that some of the hardware are in trouble but I hope is a solution to this issues Thanks a lot to everyone and fell free to give your advice in this again Thanks.
      My Computer


  2. Posts : 1
    Windows 7 Ultimate x64
       #2

    when booting it always appear reboot and select proper boot device. after restart it boots
      My Computer

  3.    #3

    Boot into BIOS setup to make sure the drive you want to boot is set first in BIOS boot order.

    If you're trying to boot a disk it should then prompt to "Press any key to boot disk" or the disk is not good.

    If you're trying to boot HD and it fails then boot into System Recovery Options via tapping F8 key or if not there using WIn7 DVD or System Repair Disk to run Startup Repair - Run up to 3 Separate Times.

    If this fails start a new thread for help and begin working through these steps for Troubleshooting Windows 7 Failure to Start
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 01:15.
Find Us