Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Toshiba p505s8000 fail to boot with 2 beeps

19 Sep 2012   #11
Hassnain

windows 7 ultimate 32 bit
 
 

Mr. , when this kind of thing happens, there certainly is a maltfunctioning in ram, try installing new ram


My System SpecsSystem Spec
.
19 Sep 2012   #12
gregrocker

 

You can try removing a RAM stick, swapping them, checking for debris in slot. No way to test if you don't get image on screen for BIOS post, though you can try booting Memtest86+
My System SpecsSystem Spec
19 Sep 2012   #13
jumanji

Windows 7 Home Premium 32 bit
 
 

Hi DrZuhoch,
If your Toshiba Laptop came with AMI BIOS (American Megatrends),two beeps means there has been a parity error in base memory (RAM). This is an issue with the first 64KB block of memory in your RAM. The solution is usually to replace the memory.
My System SpecsSystem Spec
.

20 Sep 2012   #14
DrZuhoch

Windows 7 Ultimate x64
 
 

I have ordered new ram.I will keep you posted of results.
Thanks for all the help!
My System SpecsSystem Spec
25 Sep 2012   #15
DrZuhoch

Windows 7 Ultimate x64
 
 

I ordered new memory, and installed today.Same problem no difference.The hard drive has power, and is running, but computer will not boot up.
Fans start,disk drive is queried.
Sometimes, if I continuously power down and attempt restart, it will start up.
The last time it powered up, I left it running for 3 days till my memory modules came in.Of course, I had to shut down to install modules,, but it would not boot up again.
While it was up, I looked at system status, and memory and hard drive showed very few hard errors.
What else could be causing this problem?, It seems to be intermittent on boot up, but once up, it runs fine.
Thanks for everyone's help and advice on this problem.
My System SpecsSystem Spec
25 Sep 2012   #16
gregrocker

 

I gave you a whole list of Troubleshooting Steps for Windows 7. Have you completed them?

You should also consider getting a baseline perfect Clean Reinstall - Factory OEM Windows 7 to a HD wiped with Diskpart Clean Command so you can eliminate software as the culprit. Follow the steps in the tutorial as closely as possible.
My System SpecsSystem Spec
Reply

 Toshiba p505s8000 fail to boot with 2 beeps




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
powers on but no display, boot, beeps
i have this pc about 7 yrs. it powers on but no disp. boot beeps, but the fans, hdd, dvd rom works. my psu is not branded btw. 540w, and the prob occured when i smelled something burned or toased. i just cant tell surelly. note: i have no vcard, also tried reseating cmos. checked the cpu hsf...
Hardware & Devices
Factory Restore Toshiba password and username fail
I factory restored my toshiba satellite after I couldn't remove a file that was causing a virus. We had a few problems but I finally figured it out, but when it finished finalizing it took me straight to entering my password to get in to my laptop but it never got me to set my username and password...
Hardware & Devices
Three beeps at boot and no video
Have a custom made desktop running 7 32bits on an Intel DG43NB board 4GB and a Q0650 processor. I recently acquired this machine for nothing and changed the thermals and did a good clean up and it has been running fine as my tester until last night when I booted it went to get a coffee came...
BSOD Help and Support
Installed new video card now no boot and no beeps
I've been building and upgrading PCs for a while and never had this happen before. Any help would be great! I'm running on an Intel DP55WB motherboard with a PCIe 2.0 x16 I pulled the old Radeon 4600 series video card and put in a XFX Radeon HD 6770. When I try to boot it up, the lights and...
Graphic Cards
Computer Won't Boot - No Beeps, No Video Output
Hello, So I recently assembled a new computer, connected everything started it up - got no output even though I could hear drives spinning and everything "appeared" to work, so I stripped it right back to just the motherboard, CPU (heatsink) and PSU - I do realise that it won't POST without RAM...
Hardware & Devices
Boot Manager & Beeps
Hey all, and thanks in advance for helping me or attempting to! My laptop has been just recently, as in about a week ago, been constantly booting to the Boot Manager upon startup (actually, it literally started happening after I (thought) I removed a virus/trojan/malware from that cursed...
Performance & Maintenance


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 22:12.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App