|25 Sep 2012||#1|
| || |
I have a problem with missing RAID array, Normally I use hardware RAID, but I decided to give MS a try. I work some some time now, but when I came back (or maybe before I left) I did some update to my pc. I think one of them warned me to b/u my stuff, but just like many of us, I didn't pay it any attention.
I have three WD hd set up in an a array. When I came back I noticed that I couldn't access them from my other pc; resulting in chk'n out the source, and sure enough the files were missing. Went to manager and disk manager indicate that I need to format my E: drive (this is the drive letter given to the array, and I should inititialize the other two drive. Is there anyway I can re-configure these drive without losing data. I haven't done anything to them for that last couple of week - keeping hope that I can find a solution.
All note would be appreciated..
|My System Specs|
|Similar help and support threads for2: software raid|
|Win7 Software RAID||General Discussion|
|Can you install software raid 0 for c:?||Installation & Setup|
|Windows 7 Software RAID||Installation & Setup|
|Software Raid 1 problem||Installation & Setup|
|RAID (Software or Hardware)||Hardware & Devices|
|Software Raid 0 on C:||General Discussion|
|Our Sites ||Site Links ||About Us ||Find Us |
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.
© Designer Media Ltd
All times are GMT -5. The time now is 11:26 AM.