Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: HP 4510s windows7 "Non-system disk or disk error replace..."

26 Dec 2012   #1
tazloccsta39

windows 7 32 bit
 
 
HP 4510s windows7 "Non-system disk or disk error replace..."

HP probook 4510s windows 7 32bit
I did a "disk sanitizer" and the laptop isn't rebooting right or reading my operating system cd it says "NON-SySTEM ERROR OR DISK REPLACE AND STRIKE ANY KEY WHEN READY"
1) i removed all assceraries from the leptop
2) ran a diagnostic test all passed
3) here are some photos attachments
4) i think i deleted the partition and the OPS wind.7
Please thanks





Attached Thumbnails
-photo-1.jpg   -photo-2.jpg   -photo-3.jpg  
My System SpecsSystem Spec
.

27 Dec 2012   #2
gregrocker

 

What is a "Disk sanitizer." Sounds like a disk wiper, or some optimizing or registry cleaning crapware that ruined your Win7.

Try booting into the Win7 DVD or Repair CD to System Restore to before you ruined the OS as shown in Troubleshooting Windows 7 Failure to Start which also provides the DVD if needed.

If you can't get it started with any of the steps given there then get the superior Clean Reinstall without the HP crapware which is the worst in the industry and throttles Win7 from its native state.
My System SpecsSystem Spec
27 Dec 2012   #3
symp

win 7 pro x64
 
 

Did you mean to run a Disk Sanitizer?
Knowing that it was going to completly erase your harddrive and make anything un-recoverable?
Sounds like you did, as your stated it wont boot of your CD either.
Have you checked the bios to insure that the boot options include the CD drive?
I am not familiar with your laptop, but I assume there is also a boot menu.
Usually Laptops hide it in some kind of bios option that says boot options load time 0, 5, 10seconds.
Turn that on, if not.. and you should see your boot options f12 or f11 or whatever it is.
Then select your DVD/CD when your prompted too.
My System SpecsSystem Spec
.


Reply

 HP 4510s windows7 "Non-system disk or disk error replace..."




Thread Tools





Similar help and support threads
Thread Forum
HDD shows in "Device Manager" but not in "DiskPart"or" Disk Management
Hi Guys, any ideas how to access my external hard drive device manager can see it but it does not appear in disc management. I use this HDD perfectly in my car HDD player. But when I try to connect it to my Laptop, it does not show up in disk management. Please check the attached screen...
Hardware & Devices
Hard Disk can't read in "my computer ", "initialized",I/O device error
I have a big problem here, I have used my hard disk for 9month, Yesterday when I watched movie on the half way, My hard disk suddenly disfuntion, And I thought my laptop problem due to always lagging so I restart my computer. But after that I can't read my hard disk (WD)in my computer. It can...
Hardware & Devices
"System Reserved (C:)" and "Local Disk (D:)" ??
Newbie here. I have searched around for a while but have not found a post with my exact situation. I just installed a new Seagate Momentus 500gb (7200rpm) SATA drive in my Lenovo X61 laptop and have been working on a installation of Windows7 Ultimate. Not realizing this was an upgrade...
Installation & Setup
Help please! "Non-System disk or disk error" after repairing MBR
I just attempted to use Partition Wizard to repair my MBR after installing Ubuntu and having issues with a BSOD in Windows (0xC0000225). Now when I reboot all I get is "Non-System disk or disk error." Any ideas? I can't run fixmbr using a recovery disk because apparently that command no longer...
Installation & Setup
"Disk boot failure, insert system disk and press enter"
Pretty much what happened is that my powersupply got messed up one day and just turned off my computer and I couldn't boot it back up. I ordered a new PSU and I installed it but now when I boot my computer I'm getting "Disk boot failure, insert system disk and press enter". I've tried putting in...
General Discussion
Disk Management hangs at "Loading disk configuration information"
When trying to view my disks in Computer Management>Disk Management, I get "Connecting to Virtual Disk Service" for several minutes, then "Loading disk configuration information" nearly forever. After about 20 minutes, some information appears, but I can't scroll the window to see all the data. ...
Performance & Maintenance

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 01:01.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App