windows failed to start mvs91xx.sys missing or corrupt.


  1. jorpe
    Posts : 278
    7600x64 ultimate, not SP1
       New #1

    windows failed to start mvs91xx.sys missing or corrupt.


    This happened after I re-installed drivers for a marvell add in sata 6 card. I booted into another OS and replaced the file in the drivers folder but it did the same. Is there any way I can remedy this situation without doing a repair install?

    win7x64 gigabyte x58a-ud5 v1. SSD is samsung evo 840.
      My Computer
    Quote Quote

  3. OldMX
    Posts : 687
    Microsoft Windows 10 Professional / Windows 7 Professional
       New #2

    Load a previous system restore check point?
      My Computer
    Quote Quote

  4. jorpe
    Posts : 278
    7600x64 ultimate, not SP1
    Thread Starter
       New #3

    OldMX said:
    Load a previous system restore check point?
    can I get there from a repair disc? I cant even boot to safe mode.
      My Computer
    Quote Quote

  6. jorpe
    Posts : 278
    7600x64 ultimate, not SP1
    Thread Starter
       New #4

    system restore says I have no restore points even though I looked earlier from within windows and there are quite a few
      My Computer
    Quote Quote

  7. jorpe
    Posts : 278
    7600x64 ultimate, not SP1
    Thread Starter
       New #5

    solved... booted to win 8 on a different drive and after trying several versions of that missing file with no success one file finally got it to boot by dropping it into windows/system32/drivers
      My Computer
    Quote Quote

 

  Related Discussions
I've been getting an error message every time I try to upgrade my Win7 Pro install to Win10. When I researched the issue I discovered that somehow my system partition was only 37MB instead of the usual 100MB that Windows creates when installing. This probably because I cloned the drive from a 1TB...
Hi Guys i got an error while activation of windows 7 error codes 0x8007007b and also key management service (kms) binding is missing or corrupted. steps i have done : 1. Run windows tweaking tool 2. SFC scan - no corrupted files 3. checked for virus
Hi I am trying to fix my grandaughters acer asprire one d 255 it will not boot up . Says file:windows\system32\winload.exe status oxoooooof info: the selected entry could not be loaded because the application is corrupt when i try to restore to factory settngs only gets to 16 % and gives a...
hi, basically I have an Acer Aspire 5738Z notebook it was going a bit slow recentley so I decided to wip it clean and start again, before I even had the chance to think about rebooting it the wholoe thing shutdown and failed to boot. I thought this was my chance to wipe the whole think clean (using...
I have an Macbook Pro with an Intel processor, which I have partitioned as a dual boot and have Windows 7 Ultimate X64 installed. This setup has ran fine until last week. I installed an old Guitar DVD course, and the default video player was Windows Media Player. For some reason the videos would...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 09:15.
Find Us