|20 Jul 2012||#1|
| || |
Can't Boot Windows in PCI-e Slot 1
When I boot up my computer, it POSTs nicely displaying all the POST information. I have Windows 7 drivers set to visibly load and when that finishes, my BenQ XL2420T monitor displays "No Signal!" and I have a blank screen. If I disconnect the cable, I get the "No Cable Connected!" message from the monitor. When I reconnect the cable, the "No Signal!" message appears along with the blank screen again. This occurs with an Asus GTX 580 Matrix in PCI-e Slot 1 (closest to the processor) with a Display Port cable. Moving to the next available PCI-e slot results in a flawless Windows 7 bootup sequence. Am I doing something wrong? Is there something I need to enable or disable in BIOS? Any help is appreciated thank you.
Motherboard: Asus Maximus IV Extreme-Z
Graphics card: Asus GTX 580
Monitor: BenQ XL2420T
OS: Windows 7 Ultimate x64
System memory: 16GB Corsair Vengeance
PSU: Corsair AX850
|My System Specs|
|Similar help and support threads for2: Can't Boot Windows in PCI-e Slot 1|
|New Ram, Which Slot?||Performance & Maintenance|
|RAM displaying different CAS in each slot?||Hardware & Devices|
|RAM slot not seeing RAM||Hardware & Devices|
|pcie 2.1 gpu in 1.0 slot?||Chillout Room|
|AMD Slot A and runing Windows 7||General Discussion|
|PCI slot x16||General Discussion|
|Graphics Card/ PCI-E Slot Issue On Boot-up||Graphic Cards|
|Our Sites ||Site Links ||About Us ||Find Us |
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.
© Designer Media Ltd
All times are GMT -5. The time now is 03:47 AM.